Half Circle Wall Cookware Rack
Model CRHC-22
Beautifully display Cuisinart
®
Cookware and keep
it within easy reach. This Cuisinart
®
Cookware
Rack eliminates the need to bend down to stack
and store cookware in cupboards. The rack is
easy to install and designed to last a lifetime.
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Note: Please proceed carefully, using the following instructions to assure this rack is assembled properly for safe
installation and use and without damage to the nish. Haste in assembly or installation could result in needless
scratching or marring of the nish.
ASSEMBLY
1. Unwrap rack and mounting arm from plastic covering.
2. Attach the arm to the rack body using the lock star washer and ½" hex nut. Tighten securely.
INSTALLATION
1. Remove mounting hardware from plastic bag and check against parts list above.
2. Identify mounting location and ensure at least the two base mounting holes are located directly over wall
studs (wood studs).
3. Position rack assembly in desired location and mark fastening locations for base and mounting arm using
rack holes provided.
4. Drill mounting holes and mount rack according to your situation.
a. For all-wood installation
i. Drill three holes as marked using a
7
/32 drill bit (not provided).
ii. Hold rack in position (you may want assistance during this step) and fasten base to wall rst using
the 2½" lag screws and washers provided. Tighten securely.
iii. Finish by securing the mounting arm with the third 2½" lag screw and washer, tighten securely.
b. For wood and sheetrock installation
i. Ensure base mounting holes are located over wood wall studs.
ii. Drill base mounting holes as marked using a
7
⁄32" drill bit (not provided).
iii. Drill mounting arm hole as marked using a
3
⁄8" drill bit through sheetrock.
iv. Insert small washer on screw rst, then larger washer second. Pass through bracket mounting hole
and attach anchor to screw.
WARNING:
PLEASE READ ALL INSTRUCTIONS
BEFORE ASSEMBLING AND INSTALLING
YOUR NEW COOKWARE RACK
Rack Size: 25" Length x 12" Width x 15½" Height
OVER, PLEASE
Enclosed you will nd everything needed for the proper assembly and use of your cookware rack.
The parts and hardware included are:
1 Star Washer
3 2½" Lag Screws
3 Lag Screw Washers
1 Sheetrock Anchor Washer (toggle)
1 Wall Half Circle Base
1 Mounting Arm
6 Angled Pot Hooks
1 ½" Hex Nut
1 Sheetrock Anchor
1 Sheetrock Anchor Screw
Mounting Arm
Anchor
Star Washer
Washer
½" Hex Nut
Lag Screw
Welded
Bolt
Pot Hooks (6)
Anchor Screw
Base
Anchor Washer
Loading ...
