Loading ...
Loading ...
Loading ...
component cooling process before turning off the fan. Once the desired
temperature is achieved, the heater will maintain the room to the set
temperature.
7. SETTING THE TEMPERATURE
Choose the desire Mode: ECO, HIGH, or LOW. To set the desired
temperature:
Press the button once
until the numeric temperature starts flashing.
Press the button again to increase the temperature or the button
to decrease the temperature.
Once the temperature is set, the heater will warm up the room using the
selected Mode. Heater will sample the room temperature every 4 minutes
after the desired temperature is reached.
8. Night Mode
Night mode is design for quiet operation in the night. You can press and hold
MODE button and then press button to set the night mode. The display
will show "ni". In this mode, when the heater reached the set temperature, it
will sample the room temperature less frequently, 30 minutes per sample.
Press and hold the Mode and then press button to cancel the night
mode. Display will show set temperature again
9. Display the room temperature
The display shows the set temperature all the time, press and hold the
MODE button and then press the button. The room temperature will
display for 30 seconds. It will return to set temperature after 30 seconds.
10. SETTING THE HUMIDIFIER
Make sure the humidifier has been fully inserted into the two hooks in the
rear side of the wooden box. Then press the Humidifier button to set to the
Humidifier mode. The humidifier will shut off automatically when the water
level is low. Refill the humidifier with distilled water, the humidifier will turn on
again.
CAUTION: To prevent leakage, do not move the heater quickly when the
humidifier is filled with water.
Remote Controller
HOW TO INSERT BATTERIES
NOTE: Remove the batteries if the remote control is not to be used for a month
Loading ...
Loading ...
Loading ...