Loading ...
Loading ...
Loading ...
16 / EN
Cooker Hood / User Manual
A
ATTENTION: Since twists and
bends in the aluminium pipe will
lead to reduction in the air suction
power, avoid using twists and bends
as much as possible.
5.4 Connecting to flue
(Figure 7)
1. Flap pin socket
2. Flap pin
Insert the plastic pin (Figure 7/area no. 2) on the
pin socket on the motor exhaust (Figure 7/area
no.1). Then bend the flap lightly to insert the oth-
er pin on the flap and insert the other pin to its
socket.
If you are going to use the Ø 120/150 mm adapt-
er, connect one end of the pipe to this adapter, if
you are not going to use it, to the direct output on
the product. Connect the other end of the pipe to
your flue. Check that these two connections are
tight enough so they will not come out when the
appliance runs on full power. Ensure that the flaps
inside the flue work when tightened with clamp.
Connect the flue connection pipe outside the
adapter (Figure 8/a). If the connection pipe is fitted
inside the adapter, the flue flaps that prevent air
return shall remain closed and air won’t be sucked
in (Figure 8/b).
5 Installation of appliance
The length of the pipe connection as well as the
number of elbows must be as minimum as pos-
sible.
A : Flue outlet pipe
B : Flue flaps
C : Plastic flue
The flue flaps are closed then the appliance is not
operating and prevent possible outside odour and
dust from entering inside.
(a) (b)
Suitable Not suitable
(Figure 8)
Loading ...
Loading ...
Loading ...