Loading ...
Loading ...
Loading ...
Alignment (continued)
Adjustment of Miter Scale Indicator
1. Loosen the phillips screw that holds the indicator in
place..
2. Reposition the indicator and retighten screw.
WARNING: To avoid injury from unexpected
starting or electrical shock, do not plug the saw
in. The power cord must remain unplugged
whenever you are working on the saw.
Step Two-Bevel Adjustments
NOTE: Bevel Adjustments are only perfomred on
model 113.235221, compound miter saw. If you have BEVELPIVOT
Model 113.235110 saw, proceed to "Mounting Miter ADJUSTMENT
Saw" section.
Bevel Stop Adjustments (RECESSED)
NOTE: The miter saw was assembled, aligned, and
inspected before shipment. Alignment should be
checked and any adjustments made to insure accurate
cuts.
1. Check miter lock knob setting. The miter lock knob
should be at the 0° position. To reset the miter angle,
turn the miter lock knob counter clockwise and press
down the index spring.
2. Lower the power head and lock the stop shaft. Make
sure the bevel index pin is pushed in. Loosen the
bevel lock knob and tilt powerhead until it contacts
the 45° stop.
3. Using the square, check for accuracy of the 45° stop
(when the blade makes contact with the full length of
the square). Do not measure across the set of a
blade tooth. Repeat this for 0° bevel. If either stop is
inaccurate, follow the alignment procedures: a
through g.
a. Using the allen wrench provided, loosen the
screw which holds the inaccurate bevel index
stop.
b. Move the power head left or right until blade
makes contact with full length of square.
c. Tighten bevel lock knob.
d. Make sure the index pin is pushed in.
e. Slide bevel index stop over until it firmly contacts
the index pin.
f. Tighten bevel index stop screw.
g. Recheck indexes for accuracy.
4. Check the bevel indicator. If indicator needs adjust-
ment use the phillips end of the combination wrench
supplied and slide the indicator to the correct reading
on the scale and retighten screw.
Bevel Pivot Adjustments
1. The miter saw should bevel easily by loosening the
bevel lock knob and tilting the power head to the left.
If movement is tight or if there is looseness in the
pivot follow the adjustment procedure: a through c.
a. Loosen the bevel lock knob.
b. Turn the hex head screw with 1/2" socket clock-
wise to tighten or counter clockwise to loosen.
c. Recheck bevel movement of the miter saw.
Readjust if necessary.
BEVEL
LOCK KNOB
BEVELINDEX
STOPS
BEVELINDEX
PIN
REAR, BOTTOM
VIEW FROM BACK
11
Loading ...
Loading ...
Loading ...