Loading ...
Loading ...
Loading ...
OTHER
• Do not stor_ gasoline from one season
to another,
° Replace your gasoline can if your can
starts to rust, Rust and/or dirt in your
gasoline will cause problems.
• If possible, store your unit indoors and
cover it to protect it from dust and dirt,
° Cover your unit with a suitable protective
cover that does not retain moisture, Do
not use plastic, Plastic cannot breathe,
which allows condensation to form and
will cause your unit to rust.
IMPORTANT: Never cover mower while
_gine and exhaust areas are still warm,
CAUTION: Never store the lawn mowel
with gasoline in the tank inside a building
where fumes may reach an open flame or
spark. Allow the engine to cool before stor
ing in any enclosure°
TROUBLESHOOTING - See appropriate section in manual unless directed
to a Sears Parts & Repair Center.
PROBLEM CAUSE
Does not start
1. Dirty air filter.
2. Out of fuel.
3. Stale fuel.
4. Water in fue!,
5_ Spark plug wire is
disconnected.
6. Bad spark ptug_
7, Loose blade or broken
blade adapter.
8. Control bar in released
position,
9. Control bar defective.
10. Fuel valve lever (if so
equipped) in OFF position°
t 1, Weak battery (if equipped)°
12. Disconnected battery
connector (if equipped).
13. Engine control lever is
in STOP position.
1, Rear of lawn mower
housing or cutting blade
dragging in heavy grass,
2, Cutting too much grass_
3o Dirty air filter°
4, Buildup of grass, leaves,
and trash under mower,
5. Too much oil in engine.
6, Walking speed too fast.
1. Worn, bent or loose blade.
2_ Wheel heights uneven,
3o Buildup of grass, leaves
and trash under mower.
Loss of power
Poor cut .-
uneven
CORRECTION
1. Clean/replace air filter,
2, Fill fuel tank,
3. Drain fuel tank and refill tank
with fresh, clean gasoline,
4, Drain fuel tank and refill tank
with fresh, clean gasoline.
5_ Connect wire to plug_
6. Replace spark plug.
7. Tighten blade bolt or
replace blade adapter,
8o Depress control bar to
handle.
9, Replace control bar.
t0o Turn fuel valve lever
to the ON position.
11. Charge battery°
t2. Connect battery to engine,
13o Place engine control lever
in FAST position.
1o Raise cutting heighL
2. Raise cutting height,
3. Clean/replace air filter,
4o Clean underside of mower
housing_
5o Check oil level
6, Cut at slower walking speed,
1. Replace blade, Tighten
blade bolt.
2. Set all wheels at same
height.
3. Clean underside of
mower housing,
17
Loading ...
Loading ...
Loading ...