Loading ...
Loading ...
Loading ...
86 - CLEANING AND MAINTENANCE 914779721/A
Programmed pyrolytic function
It is possible to program the Pyrolytic cycle start
time like all other cooking functions.
1. After confirming the desired pyrolytic
function duration, touch next to the expected
end time of the function.
2. Scroll with your finger to select a different
time for the pyrolytic function to finish.
3. Press the CONFIRM button to confirm.
The appliance waits until the set start time to start
the Pyrolytic function, showing the relevant
countdown.
End of Pyrolytic function
When the temperature inside the oven cavity
has fallen to safe levels and the door lock has
been deactivated, open the door and collect
the residues inside the oven cavity with a damp
microfibre cloth.
Extraordinary maintenance
Seal maintenance tips
The seal should be soft and elastic.
• To keep the seal clean, use a non-abrasive
sponge and wash with lukewarm water.
Replacing the internal light bulb
1. Completely remove all accessories from
inside the oven.
2. Remove the rack/tray support frames.
3. Use a tool (e.g. a spoon) to remove the bulb
cover.
4. Slide out and remove the light bulb.
5. Replace the light bulb with one of the same
type (40 W).
6. Refit the cover. Ensure the moulded part of
the glass (A) is facing the door.
7. Press the cover completely down so that it
attaches perfectly to the bulb support.
If the pyrolytic cycle gives unsatisfactory
results at minimum duration, it is
recommended to set a longer time for
subsequent cleaning cycles.
It is not possible to select any function
once the door lock device has been
activated. It is still possible, however, to
switch off the appliance pressing the
ON-OFF button.
We recommend wearing rubber gloves
for these operations.
For easier manual cleaning of parts that
are difficult to reach, we recommend
removing the door.
Power voltage
Danger of electrocution
• Unplug the appliance.
• Wear protective gloves.
Take care not to scratch the enamel of
the oven cavity wall.
Do not touch the halogen light bulb
directly with your fingers, use an
insulating material.
Loading ...
Loading ...
Loading ...