Loading ...
Loading ...
Loading ...
Removing residual matter inside the water supply line after installing filter
1. Turn ON the main water supply.
2. Press the Water button and push the dispenser pad.
3. Flush 3 gallons of water through the filter befor use.
(Flush approximately 6 minutes.)
This will clean the water supply system and remove air from the lines.
4. Additional flushing may be required in some households.
5. Open the refrigerator door and make sure there are no water leaks coming
from the water filter.
Ice
ater
A newly installed water filter cartridge may cause water
to briefly spurt from the water dispenser. This is due to air
getting into the line. It should pose no problem to operation.
Check the amount of water supplied to the ice tray
1. Lift up and pull out the Ice maker bucket in the freezer.
2. When you press the Test button for 3 seconds, CHECKTHEWATERLEVEL
the ice cube container is filled with water from
the water supply tap. Check to make sure the
amount of water is correct (see the illustration).
If the water level is too low, the ice cubes will be
small. This is not a problem with the ice maker
but of the water pressure in the pipe.
When this problem occurs, contact the dealer
service center to check the amount of water
supplied.
Feeler Arm
!
t_i :<'// ,_ ,'
[ ,'_ , fo_ t,
TEST BUTTON P_
TOO LOW
3. In case ice does not come out, pull out the ice bucket and
press test button located on the bottom of ice maker.
setti*_gup 19
Loading ...
Loading ...
Loading ...