Loading ...
Loading ...
Loading ...
7
Before installation, ensure the fan is unplugged from the power supply and
turned off before commencing assembly.
1.
Unscrew the screws from the Metal Tube.
2.
Insert the Metal tubes into the Metal Base, re-insert and tighten the
screws.
Always operate the fan in the upright position following all instructions and
recommendations listed in this manual.
Place the fan in the area of the room that will provide proper fan cooling.
Plug fan directly into 120 volt A.C., 60 Hz wall outlet. Be sure plug fits tightly in
outlet. A loose connection may cause overheating and damage to the plug or
fan. NOTE: To prevent overloading a circuit, do not plug the fan into a circuit
that is servicing other electrical needs.
Place the fan on stable level surface. Plug fan into properly grounded outlet. To
start the fan, turn the switch from the OFF position to the desired fan speed.
To turn the fan off, turn the switch from the current fan speed setting to the off
position. Remove plug from outlet.
To adjust the tilt angle, use a knob wrench to loosen the adjustment screw. After
adjustment, retighten the adjustment screw.
ASSEMBLY INSTRUCTIONS
ASSEMBLY OF THE METAL BASE
OPERATING THE FAN
Loading ...
Loading ...
Loading ...