Loading ...
Loading ...
Loading ...
8
Emergency Cause Possible Solution
Gas leaking from cracked, cut or
burned hose
Damaged hose Turn o gas at LP cylinder.
Replace hose.
Contact Customer Service at 1300 174 876.
Gas leaking from LP cylinder Failure due to rust or mishandled equipment Replace LP cylinder.
Gas leaking from gas cylinder valve Failure of valve due to rust, mechanical
failure or mishandled equipment
Turn o gas cylinder valve and return
cylinder to gas provider/supplier.
Gas leaking between LP cylinder
and regulator connection
Improper installation, connection not tight
enough, damaged threads or bad rubber seal
Turn o gas cylinder valve, then re-attach
regulator to cylinder.
Turn o gas cylinder valve and return
cylinder to gas provider/supplier.
Visually inspect rubber seal for damage.
Fire under control panel Fire in tube of burner due to burner blockage
Turn o both burner control knobs and gas
cylinder valve. Once the re is out and burner
has cooled, remove and inspect burner for
spiders, nests, rust or other debris.
Grease re or excessive/
continuous ame
Grease build up on or around burner area
Turn o both burner control knobs and gas
cylinder valve. Allow ames to extinguish and
time for unit to cool down. Clean grease/food
particles from/around burner or burner area
and surrounding surfaces.
WARNING
In the event of a gas leak that cannot be stopped, or if a
re occurs due to a gas leak, contact the re department.
TROUBLESHOOTING GUIDE
Symptom Cause Possible Solution
Low ame output* Out of fuel Rell or replace with full LP cylinder.
Flames blow out* Low on LP gas Rell LP cylinder.
Flare-up Excessive grease buildup Clean burners and inside unit.
Excessive fat on meat Trim fat o of meat.
Cooking temperature too high Adjust or lower temperature accordingly.
Persistent grease re Grease trapped by food buildup around
burner system
Turn burner control knobs and gas cylinder valve o.
Allow re to extinguish and the unit to cool down. Once
cool, remove and clean parts.
Flashback (re in burner tube) Burner and/or burner tube has blockage Turn burner control knobs and gas cylinder valve o.
Clean burner and/or burner tube.
Slower than expected cooking
times*
Valve not properly aligned to burner Check to see if valve is centered in burner tube.
MATCH LIGHT INSTRUCTIONS
1. Read all instructions and warnings before lighting.
2. Check gas control valve and gas cylinder valve to be certain it is in OFF position before connecting
to gas cylinder.
3. Perform soapy water test before each use.
4. Open door(s) during lighting and/or remove all accessories and cooking vessels from in/or on unit.
5. Turn gas cylinder valve on, then turn gas control valve on.
6. Place a long, lit replace match stick close enough to burner to ignite.
7. If ignition does not take place within ve seconds, turn gas control valve to OFF position and wait
ve minutes and repeat match light instructions.
8. After each use, rst turn gas control valve o, then gas cylinder valve o. Always allow unit to cool
completely before touching, moving or storing.
Loading ...
Loading ...
Loading ...