Loading ...
Loading ...
Loading ...
5
SMOKER OPERATION - READ & FOLLOW ALL INSTRUCTIONS CAREFULLY
GETTING STARTED
Pre-season unit prior to rst use. See PRE-SEASON INSTRUCTIONS.
Before starting the unit, see ADDING WOOD CHIPS OR CHUNKS.
CAUTION - All surfaces are HOT and may cause burns. Use protective gloves or long, sturdy cooking tools when loading/
unloading food or racks, and when adding wood chips or water.
PRE
-
SEASON INSTRUCTIONS
Curing your smoker will rid the unit of chemicals and oils left over by the manufacturing process allowing them to burn o󰀨.
PRE-SEASON SMOKER PRIOR TO FIRST USE.
1. Perform soapy water test, see SOAPY WATER TEST WARNINGS AND PROCEDURES.
2. Using a napkin or cloth, rub a light coat of cooking oil on smoking racks and inside smoker door. Make sure water pan is in place with
NO WATER.
3. Fill wood chip tray with up to 1 cup (0.24l) of wood chips or chunks and light smoker. Close door.
4. Start smoker and let the smoker burn for about 1 hour. Make sure temperature gets up to 350°F (177°C).
5. Allow unit to cool COMPLETELY.
6. Reapply light coat of cooking oil on smoking racks and inside of smoker door.
7. Restart smoker and burn for 20 minutes.
• Cure your smoker periodically to prevent excessive rust.
ADDING WOOD CHIPS OR CHUNKS
1. You may use dry or pre-soaked wood chips or chunks in your smoker. Dry chips or chunks will burn faster and produce more intense
smoke. Chips or chunks pre-soaked in water (for approximately 30 minutes) will burn slower and produce a less intense smoke.
2. DO NOT ADD MORE THAN 1 CUP (0.24l) OF WOOD CHIPS OR CHUNKS AT A TIME. Never use wood pellets.
3. Place additional wood chips or chunks in smoker as needed to achieve desired smoke avor.
Wood chips or chunks must be used in order to produce smoke and create the smoke avor.
OPERATING INSTRUCTIONS
1. To start smoker see IGNITION INSTRUCTIONS.
2. With protective gloves on, place water bowl in position. Pour 1 inch of water, juice, or vinegar into water bowl. This will add avor and
moisture to food and prevent it from drying out.
3 DO NOT cover racks with aluminum foil as this will not allow heat to circulate properly.
4. Pre-heat smoker for 30 to 45 minutes at max temperature before loading food.
5. Place food in the smoker, position on the center of the smoking rack.
6 DO NOT overload smoker with food. Extra large amounts of food may trap heat, extend cooking time and cause uneven cooking. Leave
space between food on racks and smoker sides to ensure proper heat circulation. If utilizing cooking pans, be sure pans do not cover
more than 75% of the rack space and place pans on center of rack to ensure even cooking.
7. For best results, rotate racks between the top and bottom positions during cooking.
8. Adjust smoker settings, control knob and air dampers, to desired cooking temperature.
Close all air dampers on unit to retain moisture and heat. If cooking foods such as sh or jerky, open air dampers to release moisture.
9. If wood chips or chunks do not smoke on low setting, increase temperature to 275°. After 8 to 10 minutes or when wood chips or
chunks begin to smolder, reduce temperature to desired low setting.
10. Use caution when cooking on windy days to ensure the ame does not blow out. If you suspect or experience a ame blow out, rst
open the door to check the ame and follow the IGNITION INSTRUCTIONS to re-ignite the burner if needed. Adjust the burner control
valve setting for a higher ame to prevent further blow outs. Never ignite smoker with the door closed.
11. Extreme cold temperatures may extend cooking times.
12. Once cooking is complete turn unit OFF, see IGNITION INSTRUCTIONS for turning o󰀨 unit, remove the gas cylinder and then follow
CLEANING and STORING INSTRUCTIONS. CLEAN AFTER EVERY USE. This will extend the life of your smoker and prevent mold
and mildew.
CLEANING and STORING INSTRUCTIONS
ALWAYS MAKE SURE UNIT IS COOL TO THE TOUCH BEFORE CLEANING AND STORING.
Be sure to clean smoker after each use. Make sure the gas cylinder has been turned o󰀨 and removed.
For rack supports, racks, water bowl, and drip pan use a mild dish detergent. Rinse and dry thoroughly.
For woodchip tray clean frequently to remove ash build up, residue and dust.
Dispose of cold ashes by placing them in aluminum foil, soaking with water and discarding in a non-combustible container.
For the interior, exterior and door seal of the unit simply wipe down with a damp cloth after each use to keep unit in proper working
condition. Do not use a cleaning agent. Make sure to dry thoroughly.
After cleaning, store smoker in a covered and DRY AREA.
Store only when re is completely out and all surfaces are cold.
When not in frequent use and using a cover, remember to check your smoker periodically to avoid possible rust and corrosion due to
moisture buildup.
CHECK OUT MASTERBUILT.COM FOR MORE TIPS AND RECIPE VIDEOS.
Loading ...
Loading ...
Loading ...