Loading ...
Loading ...
Loading ...
15
THERMOSTAT OPERATION
FAN SLIDE SWITCH
The FAN Slide Switch allow you to set the fan mode from ON (fan is on all the time) to
AUTO (fan cycles under thermostat control)
MODE SLIDE SWITCH
To turn the unit ON, slide the Mode Slide Switch down to the COOL position. To turn the
unit OFF, slide the Mode Slide Switch to the OFF Position.
TEMPERATURE BUTTONS
Once the MODE switch has been put into the COOL mode, push the corresponding arrow
button to lower or raise the set point to the desired temperature. The display will show
the set-point temperature with the word “SET” and will blink for 5 seconds. Then it will
return to display the room temperature. After the time delay has been satisfied, the fan
motor and compressor will start, beginning the cooling cycle. Remember, the set-point
must be lower than the room temperature for the unit to start.
AUTO
ON
COOL
OFF
TEMPERATURE
CHANGE
BUTTONS
FAN
SLIDE
SWITCH
MODE
SLIDE
SWITCH
TEMPERATURE
DISPLAY
DIGITAL, NON-PROGRAMMABLE THERMOSTAT
This is a cooling only thermostat *. Select the temperature you want by pressing the ▲ or
▼ buttons.
No batteries are required. If there is a power failure, the thermostat will start up at the last
known set point, when the power is restored.
Compressor short cycle protection is a built-in feature of the thermostat. A 4-minute time
delay will occur on start-up or when power has been restored after a power interruption.
*New cooling thermostat , effective 01-19-2016 , on units with S/N: U1
Loading ...
Loading ...
Loading ...