Loading ...
Loading ...
Loading ...
OPERATING
For large areas a definite pattern of operation is required
to thoroughly clean an area of snow. These patterns will
avoid throwing snow in unwanted places as well as
eliminating a second removal of snow. (Fig. 6)
Pattern A: Throw the snow to the right or left side where
it is possible. For areas such as a long driveway it is
advantageous to start in the middle. Plow from one end
to the other, throwing snow to both sides.
Pattern B: If the snow can only be thrown to one side of
the area to be cleared, start on the opposite side.
Scraping the snow all the way down to the pavement will
wear out the scraper and auger. To protect these parts,
one or two inches of snow can be left behind and cleared
with de-icing salt or a shovel.
After clearing the snow, continue to run the snow thrower
for a few minutes to prevent ice from freezing on moving
parts. Then switch off the motor, wait for all moving parts
to stop, remove the battery pack, and wipe the ice and
snow from the snow thrower with a clean rag.
WARNING: To avoid serious personal injury, do not use
hands or feet to unclog the chute.
Your lithium snow thrower is equipped with overcurrent
protection. When the current reaches a certain
pre-determined level, the unit will automatically slow
down until the current drops. When the current drops to a
safe level, the snow thrower will resume normal
operation.
6
10
Model SN70112-1
Loading ...
Loading ...
Loading ...