Loading ...
Loading ...
Loading ...
8
Preparation for use
Installing/removing the dust cover
The dust cover is designed to protect the product's sensitive
components when the product is not in use.
When attaching the dust cover, insert the dust cover hinges into the
two dust cover hinge holders on the back of the body. When removing
the dust cover, open the dust cover first, and then slowly pull the dust
cover out from the dust cover hinge holders.
Setting MM (VM)/MC cartridge selector
switch
If using a moving magnet (MM or VM) cartridge, set this switch to the
MM position. If using a moving coil (MC) cartridge, set this switch to
the MC position.
• This switch is set to the MM position at the time of purchase.
Because the cartridge (AT-VM95E) included with the product is a VM
stereo cartridge, keep the switch in the MM position as long as you
continue to use the cartridge.
Setting pre-amplifier selector switch
This product has a built-in phono equalizer function. You can use the
product, even if you do not have a phono amplifier or connectable
equipment with a built-in phono amplifier, by connecting an active
speaker, etc.
Use the pre-amplifier selector switch to set the output, as shown
below.
Connectable
equipment being
used
Position of
pre-amplifier
selector switch
Where to connect the
RCA audio cable
Device with phono
input
PHONO Phono input jack and
ground (earth) terminal of
connectable equipment
Device without
phono input
LINE AUX or line input jack of
connectable equipment
PC sound card LINE Sound card's line input
jack*
1
Device with USB
input
LINE USB input of your
computer*
2
*1 An audio adapter (sold separately) may be required to connect the
RCA audio cable to the PC sound card's line input jack.
*2 Use included USB cable instead of RCA audio cable to connect.
Connecting to connectable equipment (active
speakers, amplifiers, etc.)
Connecting to audio source
Align the settings for the pre-amplifier selector switch and connect
the RCA audio cable to a compatible input jack on the connectable
equipment you are using (amplifier, receiver, active speakers, sound
card, etc.).
• The RCA audio cable's red jack is for the right (R) channel, and the
white jack is for the left (L) channel.
* Depending on the equipment you are connecting, a ground (earth)
terminal may exist near the phono input jack. If this is the case,
connect to it using the ground line from the RCA audio cable. This
will help prevent a low humming noise that might otherwise be heard
during playback.
With PHONO input*
With PHONO input*
Without PHONO input
Without PHONO input
To outlet
To outlet
Connectable
equipment
(amplifier, etc.)
Loading ...
Loading ...
Loading ...