Loading ...
Loading ...
Loading ...
EN
W415-2370 / D / 12.09.20
41
electrical information
A. Before beginning installation, disconnect the gas and electrical power supply from the appliance.
B. Locate the battery housing supplied in the manual baggie.
C. Install four “AA” batteries (not supplied) into the battery housing, ensure the positive and negative ends
correspond with those identified on the holder. (To open the battery housing, slide the back piece
upwards and off of the battery housing).
D. Remove the safety barrier to easily access the control compartment.
E. Attach the wire labelled “BATTERY” from the wiring harness, located in the control compartment of the
appliance, to the battery housing.
F. Place the battery housing into the control compartment, ensuring that the battery housing is placed in a
clean and easily accessible location.
G. Reinstall the safety barrier. The safety barrier must be installed at all times during the appliance operation.
H. Turn the gas and electrical power back on to begin operating the appliance.
Red wire
Black wire
Battery housing
Control module
5.2 battery back-up installation
• Ensure the gas and electrical power to the appliance is turned off.
• Appliance may be hot. Do not service until the appliance has cooled.
!
WARNING
In the event of a power failure, your appliance can be operated using the battery back-up supplied.
note:
Once the power has been restored, remove the batteries from the holder.
note:
Loading ...
Loading ...
Loading ...