Installation and User Instructions - Page 11

The Boost connections must be connected in series with a toggle switch which allows the external boost function to be utilised.

The external boost connection on the Quantum cylinder is a contact wire which must not be connected to the mains power supply.

If an electronic timer switch from a previous installation is in place it must be replaced with a single pole toggle switch which is

wired from the B1 and B2 connections as shown in Figure 7.

The water temperature required from the boost function can then be set from the UI and the boost element will automatically turn

off once this temperature is achieved in 55 litres of the water stored.

When connected to a permanent supply, the charge period must be programmed on the cylinder user interface, see Section 7.