Loading ...
Loading ...
Loading ...
6
Product Support: Eccotemp.com/help-desk Shop Online: Eccotemp.com/products Store Locator: Eccotemp.com/locator
Eccotemp Systems LLC | Email: Support@eccotemp.com | Address: 315 - A Industrial RD Summerville, SC 29483
PLEASE NOTE: THIS MODEL IS NOT RECOMMENDED NOR HAS IT BEEN TESTED FOR ANY PERMANENT INSTALLATIONS. THIS MODEL IS PART OF OUR
PORTABLE SERIES AND NEEDS TO BE TAKEN DOWN AND STORED IN A WARM DRY PLACE AFTER EVERY USE.
THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE.
Getting Started
1. Check box for damage. Damages caused in shipment must be reported immediately.
2. Make sure you have all the parts.
Please note: Included parts and accessories may vary depending on county and regulations.
a. Water heater
b. LP gas regulator and hose
c. Shower head and shower hose
d. 1/2” NPT to garden hose adapter
e. Hardware pack
3. If using a standard garden hose, attach the 3/4” NPT to garden hose adapter to the tting marked
“Water Input”. Use “Teon” tape or other approved sealing method on the threads for a secure,
water tight t. Also, check to make sure the screen inside the water inlet is in place and clean. Then
attach your water input/garden hose.
4. Install gas supply line and regulator to the portable tankless water heater. DO NOT OVER
TIGHTEN. OVER TIGHTING MAY CRACK THE GAS REGULATOR CAUSING A GAS LEAK! Ensure that you
use Teon tape on all ttings and check for any gas smell before ignition! Make sure the gas tting
is screwed all the way on. HAND-TIGHTEN ONLY.
5. Attach the shower nozzle hose to the water output to the tting marked “Water Outlet.” Do not
over tighten.
6. Install two “D” cell batteries in the compartment on the bottom left of the heater. Check that
batteries are facing the correct direction.
7. Use the top tab on the portable tankless water heater to suspend from a mounted screw
capable of holding 30 pounds. Place at a comfortable height without putting stress on the gas hose.
Do not use suspended front of handle! Do not permanently mount this unit!
8. Attach gas regulator from the handle with hose to the LP tank. Use hand pressure only on the
plastic connector. LEAVE GAS TANK VALVE IN THE “OFF” POSITION.
WARNING!
GAS HOSE ADAPTER
THE L5,L7,& L10 PORTABLE TANKLESS WATER HEATERS HAVE A 1/4’’ TO 1/2” ADAPTER
IN THE HARDWARE PACK FOR ATTACHMENT OF THE LP HOSE TO THE HEATER.
THIS ADAPTER MUST BE INSTALLED WITH THREAD SEALANT, A SPOOL OF
SEALANT TAPE IS INCLUDED WITH THE HEATER.
MULTIPLE WRAPS OF SEALANT TAPE MAY BE
NECESSARY TO ASSURE COMPLETE SEAL.
ALWAYS CHECK FOR GAS LEAKS BEFORE USING HEATER.
Loading ...
Loading ...
Loading ...