Loading ...
Loading ...
Loading ...
Cima FF 7
MOUNTING THE FRAME
Professional mounting techniques should be used. Stewart Filmscreen can not be liable for
substandard or faulty installations.
To accurately position the frame, you will mount the hanging bar and temporarily hang the frame prior
to attaching the screen material. On the bottom of the frame, there are magnets you can slide to line up
with steel pucks you will align with wall studs. If the wall is not perfectly flat, the force of the magnet may
cause the frame to bend. For this reason, shims can be placed between the wall and the steel pucks so
that the frame lays completely flat. The screen should not be attached to the frame at this point. Refer
to figures 2-5 on page 8.
1. Identify the location of wall studs where you can securely mount the hanging bar.
2. Use a level to accurately position the hanging bar on the wall.
3. Drill holes through the bar into the studs.
4. Use the provided screws or other appropriate fasteners to secure the hanging bar to the wall studs.
Note: A minimum of three (3) screws are recommended to safely secure the frame.
5. Check to make sure the bar is level.
6. Assemble the frame (see page 6).
7. Hang the assembled frame, without the screen attached, on the hanging bar to ensure that it is cor-
rectly mounted.
8. Mark on the wall where you will mount the steel pucks that will align with the magnets fastened on
the frame.
9. Remove the frame. Drill into the studs and mount the steel pucks with the provided screws or other
appropriate fasteners. Use shims as needed.
10. Reposition the frame, slide and secure the magnets so that they align with the steel pucks mounted
on the wall.
Note: Find studs that allow the pucks and magnets to be positioned approximately 12” to 24” from
the edge of the frame on each side.
11. Remove the frame and follow the steps for attaching the screen to the frame (see pages 9-10).
12. Your Fixed Frame is now ready to hang in its final position. See figures 2-5 on page 8.
Loading ...
Loading ...
Loading ...