Loading ...
Loading ...
Loading ...
LED CONTROL PANEL
14
1. To change the drying time, WHILE
IN PROCESS, Press the + Icon to
increase the time or the — Icon to
decrease the time. The time will
increase/decrease in 30 minute
increments. When the new time is
set, the LED Display will show the
new drying time.
2. To change the temperature,
WHILE IN PROCESS, Press the
TEMP Icon then Press the + Icon
to increase the temp or the —
Icon to decrease the temp. The
temperature will increase/decrease
in 9°F increments. When the new
temperature is set, the LED Display
will automatically return to indicate
the remaining drying time.
NOTE: Verify the new temperature by
pressing the TEMP Icon.
NOTE: To reset the time and
temperature to default time of 10 hours
(10:00) and Temp of 158°F, Press the
ON/OFF Icon to turn OFF. Press the
ON/OFF Icon to turn ON. The Cut + Dry
Dehydrator will automatically return to
the default time and temperature.
When Drying Process is Complete
When the drying process is complete,
the LED Display will indicate 0:00. The
Heating Element will automatically turn
o. The Automatic Fan will turn o after
10 seconds. The Cut + Dry Dehydrator
will BEEP for 20 seconds as an indicator
that the drying process is complete. The
LED Display will display END.
Press the ON/OFF Icon on the Control
Panel to turn OFF the dehydrator.
Carefully remove food on trays, using
pot holders or oven mitts.
Unplug power cord from the wall outlet.
BEFORE FIRST USE
1. Place the Cut + Dry Dehydrator on a level, at surface that is clean and dry.
2. Ensure that the Cut + Dry Dehydrator is several inches away from
obstructions, such as walls, cabinets, doors, and other appliances. Allow
enough room above the Dehydrator so the EasyVue Door can be fully
opened.
3. Wash the Drying Trays and Protective Food Sheet in warm, sudsy water.
Dry thoroughly.
4. Use a soft damp cloth to clean the exterior of the Cut + Dry Dehydrator
and EasyVue Door. Dry with a paper towel or soft cloth.
5. Read safety instructions.
6. Press the ON/OFF Icon to start the Cut + Dry Dehydrator drying process.
Dry the interior and Drying Trays for 30 minutes before adding food. This
helps dry the interior for initial use. Smoke or odors are normal during the
initial 30 minute drying time. Allow sucient ventilation.
7. Insert Drying Trays into the Cut + Dry Dehydrator and enjoy!
MAINTENANCE
ALWAYS allow the Cut + Dry Dehydrator to cool completely before cleaning.
Unplug the Cut + Dry Dehydrator before cleaning.
After each use, clean and dry the Drying Trays and Protective Food Sheet in
warm, soapy water. Use a damp cloth to clean the Cut + Dry Dehydrator and
EasyVue Door, if needed. DO NOT immerse the dehydrator in water. Use non-
abrasive cleaners or soft soap only.
Do not place Drying Trays or Protective Food Sheet in dishwasher.
BEFORE USE & MAINTENANCE
15
Loading ...
Loading ...
Loading ...