Loading ...
Loading ...
Loading ...
Page 4 of 5
200720
Notes:
1. The sensitivity of the motion sensor will increase as the
environmental temperature gets cooler. For best
performance, gently clean the lens with a soft cloth every
1 or 2 months to ensure maximum sensitivity.
2. For best performance, install fixture at least 8 feet above
the ground. At such a height, the fixture will provide a
detection distance of up to 40 feet at 77 degrees
Fahrenheit. (See Fig.5)
3. The sensor detects movement across a detection range
of 180 degrees. (See Fig.6)
20`
8`
12`
40`
Be sure the light is mounted straight on the wall;
otherwise, the detection distance may be limited.
Fig. 5 Fig. 6
180˚
● The shut-off delay is the length of time the light will stay at brightness after motion is detected.
● You can set the shut-off delay by rotating the “TIME” knob so it points to the desired time setting (from 5
seconds to 3 minutes). To increase the shut-off delay, turn the knob clockwise. To decrease the shut-off delay,
turn the knob counterclockwise.
Shut-off Delay
Customization Options
Function and Operation
Note: When power is first applied, the light will be on. and warm up lasts 30 seconds.
1. “ ” MODE(
daytime and nighttime operation)
●
Turn the knob clockwise to“ ” position, the light turns on
after expiration of the warm-up period, It stays on when
motion is detected. When motion is no longer detected, it
remains on for the predetermined shut-off
delay time you
set (5s~3min), and then turns off automatically.
2. “ ” MODE(nighttime operation only)
● Turn the knob counter clockwise to“ ” position, the light
turns on after expiration of the warm-up period, it stays on
when motion is detected. When motion is no longer detected,
it remains on for the predetermined shut-off delay time you
set (5s~3min), and then turns off automatically.
● The light turns off automatically at dawn.
3. Manual Override MODE(nighttime operation only)
●
●
The light turns off automatically at dawn.
To shift to the manual override mode, set the mode selector
to “ ” mode. Turn the wall switch “OFF”, and turn it “ON”
twice within 3 seconds. The light will remain on all night
long. To shift back to “ ” mode, turn the wall switch “OFF”,
and turn it “ON” twice within 3 seconds again.
Note: To make sure the above functions operate properly, always keep the wall switch in the “ON” position
(including the daytime).
Fig. 3
LUX SENS TIME
Mode
Manual
Override
Manual Override Operation Diagram
Turn wall switch OFF-ON-OFF-ON
in 0.5~3 Seconds
Turn wall switch OFF-ON-OFF-ON
in 0.5~3 Seconds
Fig. 4
ASSEMBLY INSTRUCTIONS (continued)
ASSEMBLY INSTRUCTIONS (continued)
FUNCTION AND OPERATION
Loading ...