Loading ...
4.2 INSTALLING THE BLOWER
Position the blower all the way to the rear and cen-
ter in the fireplace. Pull the blower forward 1/8" to
1/4" from the back wall of the fireplace (Figure 3).
Or, you can have the two vertical brackets' "leg" stick
against to the rear wall of fireplace by Velcro strips.
4.3 INSTALLING THE SPEED CONTROL
AND SENSOR SWITCH
NOTE: Some models may have a separate mount-
ing location on the base pan or valve bracket for
mounting this speed control.
1. Remove the knob and locknut from the variable
speed control. Slide the control behind the
fireplace wall in the lower right front corner
with the stem sticking out of the pre-punched
hole. Attach the locknut tightly and reattach
the knob on the stem. Plug the blower into the
receptacle marked Rem/Aux or fan. This could
vary between models. This should be a
standard wall current or dedicated power.
2. Turn the 110-120 VAC series “ON” at the circuit
breaker and turn the speed control switch to
the “ON” position.
Unplug blower before changing
the location of the thermal
sensor. Possible electrical
shock if not unplugged.
3. The thermal sensor will turn blower on
approximately 10-20 minutes after the
fireplace is started and will continue to operate
up to 30 minutes after the fireplace has been
turned off. Times may vary depending on
sensor location.
Rubber feet may need to be removed from bracket to
install blower thorough front opening. If removed, put
the feet back on after the blower is through front
opening.
NOTE: THE SWITCH/BRACKET ASSEMBLY MUST
BE
INSTALLED SO THAT THE SENSOR SWITCH IS
TOWARDS THE TOP OF THE UNIT.
To turn off, turn dial
counterclockwise until
you hear it click.
To turn on, turn dial
clockwise from the off
position and the
blower will start on the
high setting. Continue
turning clockwise to
slow blower speed.
CAUTION
Page 2
Loading ...
Loading ...