Loading ...
Page 2 of 4
210322
Turn off the power at fuse or circuit box.
4.
Drill holes on the bottom of
the lamp tray (A) according to
the place where it will be
mounted on ceiling.
1. Detach the two screws and keep
it for step 9 of the assembly
instruction.
2. Open the front cover (B) and
disconnect the wire terminal.
Then remove front cover from
lamp tray (A).
3.
Unscrew the grub screw from
the lamp tray (A).
1
Screws
3
Grub Screw
A
4
Electric Drill
A
2
B
A
Disconnect the
wire terminals
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
● LED electronics can be damaged by electro static discharge (ESD)shock. Before installation, discharge yourself
by touching a grounded bare metal surface to remove this hazard. To avoid damage, do not touch the LED module.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
● If a dimmer control switch is used with this fixture, obtain professional advice to determine the correct type and
electrical rating required.
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Slotted Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire
Cutters, Safety Glasses, Ladder, Wire Stripper, Electrical Drill.
ASSEMBLY INSTRUCTIONS
PREPARATION
Rated Wattage: 60W
Work Temperature: -30°F~113°F
Loading ...
Loading ...