Loading ...
Loading ...
Loading ...
Battery Type
4 x AA 1.5V Alkaline
Display Screen
3.5" TFT LCD (320 x 240)
Handheld Display Unit
Operating Temperature
0°C to 45°C
lmager Head
8.5mm (0.3")
lmager Head Lights
4 x Adjustable LED
Image Sensor
1/9" VGA CMOS
lmager Head Ingress
Protection Rating
IP67 - Protected against the effect of
immersion between 15cm and 1 m
lmager Head and Cable
Operating Temperature
-10°C to B0°C
Video Output
RCA Cable
Memory
Micro SD Card
CLEANING AND STORAGE SPECIFICATIONS
1. AFTER USE, use a mild detergent on a clean cloth to remove any oil, grease or dirt from
the Camera, especially on the buttons and ports , being careful to not put excessive
pressure on the Display Screen.
2. Remove batteries before storage .
3. Store the Camera, cables and accessories in a locked area out of the reach of children.
TOOL SET UP
IAWARNING:I TO PREVENT SERIOUS INJURY FROM ELECTRICAL SHOCK:
Make sure that the Camera is OFF before performing any procedure in this section .
1. Open battery compartment by sliding battery door down
2. Insert 4 AA alkaline batteries, making sure to insert correctly according to polarity
3. Connecting Cable :
TROUBLESHOOTING
a. Carefully push Cable 's key into Cable Connector 's slot.
b. Turn Cable Connector counterclockwise until the Cable and Cable Connector
are securely attached .
4. Disconnecting Cable :
a. Turn Cable Connector clockwise until the Cable and Cable Connector are disconnected.
b. Remove Cable.
PROBLEM POSSIBLE CAUSES LIKELY SOLUTIONS
Display is on, but does 1. Cable connection loose. 1. Check that cable is connected
not show image. 2. lmager Head is dirty. 2. Clean lmager Head.
1. Light is dim at
maximum brightness.
2. Display turns itself off.
Low Batteries Replace Batteries
3. Camera will not turn on.
Slot
c,~
Connector
5. Micro SD Card:
a. Insert the Micro SD Card into the Memory Card Slot, then push down on the
card until it clicks into place .
b. When the card is installed, the
ml icon will appear on the Display Screen.
c. To remove card, push down on the card until it pops up, then remove.
6. Attaching Accessories :
a. Hold the accessory against the lmager Head, placing the Hook in the hole.
b. Match the slot on the Sleeve to the accessory, then slide the Sleeve down the
lmager Head until it covers the Hook.
"
Accessory
lmager Head
Page3 Pages
Loading ...
Loading ...
Loading ...