Read all instructions before installation, then store in a safe place for future reference.
Failure to do so may result in faulty assembly and potential injury.
SAFETY INFORMATION
• WARNING: Failure to install and wire fixture in accordance with the National Electrical Codes (NEC), all applicable Federal,
State and Local electrical codes, as well as specific U.L. safety standards for the intended working environment
(location/application), may cause serious personal injury, death and/or property damage. This product must be installed by a
person familiar with the construction and operation of the product and the hazards involved.
• WARNING: Risk of fire and electrical shock. The lights installation requires knowledge of luminaires electrical systems. If not
qualified, do not attempt installation.Contact a qualified electrician.
• WARNING: Risk of fire or electric shock. Do not alter, relocate or remove wiring, power supply or any other electrical components.
• WARNING: To prevent electrical shock, please wear rubber shoes and work gloves when installing the lights.
• WARNING: Risk of electric shock. Disconnect power at fuse or circuit breaker before installing or servicing.
• WARNING: Risk of fire. Keep the lamp heads at least 3 in. (76mm) from combustible materials.
• CAUTION: Burn hazard. Allow the light fixture to cool before touching.
• CAUTION: For wall mount installation only.
• CAUTION: Suitable for wet locations.
• CAUTION: Do not use this fixture with a dimmer switch.
• CAUTION: Minimum 105°C supply conductors.
• CAUTION: Fixture designed for wall mount above 4 ft. only. Mount fixture to a grounded standard junction box marked for use in
wet locations. Suggest to install the light fixture between 9 ft. and 20 ft.above the ground.
Important Note: The safeguards and instructions are not meant to cover all possible conditions and situations that may occur. It may
be understood that common sense, cautions and care, are factors which cannot be built into any product. The person(s) installing,
operating and responsible for the light fixture must execute these factors.
CAUTION: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limited for Class B digital device, pursuant to Part 15 of
the FCC Rules. Their limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If the equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and the receiver.
* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help.
CLEANING AND MAINTENANCE
• CAUTION: Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker off or removing
the fuse from the fuse box.
• Clean the fixture with a soft, dry cloth.
• Do not use any cleaners with chemicals, volatile solvent or harsh abrasives.
• Non-professional Do not attempt to take apart and repair the fixture .
• Please use the constant-current driver exclusively adaptive to the troffer, do not change the driver without permission .
LOCATION: Fixture can be wall mounted.
Fixture designed for wall mount above 4 ft. only. Mount fixture to a grounded standard junction box marked for use in wet
locations. Suggest to install the light fixture between 9 ft. and 20 ft.above the ground.
FEATURES:
Photocell control: At night,turns light ON automatically and turns light OFF automatically when the sun rises.
Lumens output: 7,000 lumens / 5,000K .
Note: Photocell may have a few minute delay, to reduce it's sensitivity to sudden light changes. When testing shine a
light/cover the photocell for a few minutes to check if fixture functions properly.
PREPARATION: Tools required for assembly (not included): philips screwdriver, hammer, safety goggles, power
drill, silicone sealant and ladder.
PACKAGE CONTENTS
C D
Screw x 2Wire Nut x 3
A B
Gasket x 1Light Fixture x 1
F
Lamp Shade
E
Light Base
Sku Number: 356-9419
LED Wall Light
Model Number: ES00922G
Questions, problems, missing parts?
Before returning to your retailer, call our customer service at 855-232-6423
Monday – Friday 8:00 a.m. – 8:00 p.m. (EST)
1 2
Loading ...
Loading ...
Loading ...
