Loading ...
Loading ...
Loading ...
12
INSTALLATION
Installation Place Requirements
Before installing the appliance, check the following information to make sure that the
appliance should be installed in a correct place.
Installation Location
WARNING
Do not install the appliance around a
heat source. The rear side of the
appliance must be well ventilated.
Failure to follow these instructions
may result in problems.
The appliance is not designed for
maritime use or for use in mobile
installation such as caravans, aircraft
and etc.
Do not install the appliance as a built-
in appliance. It is not suitable for built-
in purpose.
NOTE
For better drying performance, keep
the rear of the appliance away from
the wall.
Make sure that the location where the
appliance will be installed meets a
minimum clearance conditions.
Install the appliance on a flat hard
floor. Allowable slope under the
appliance is 1 degree.
Never try to correct any unevenness in
the floor with pieces of wood,
cardboard or similar materials under
the appliance.
Install the appliance in a location
where service engineers are easily
accessible in the event of a breakdown.
Do not install the appliance next to
high-temperature appliances such as
refrigerator, oven or stove, and etc. It
can cause poor drying performance
and delay programme duration. It also
adversely affect the proper functioning
of the compressor.
Do not install the appliance where
there is a risk of frost or dust. The
appliance may not be able to operate
properly or may be damaged by
freezing of condensed water in the
pump and drain hose.
With the appliance installed, adjust all
four feet using a spanner to ensure the
appliance is stable, and a clearance of
approximately 20 mm is left between
the top of the appliance and the
underside of any work-top.
Ventilation
Alcove or under counter
- Ensure airflow of 3.17 m
3
/mm
through the appliance.
• Cupboard
- Cupboard door must have 2
(louvered) opening, each have a
minimum area of 387 cm
2
, located 8
cm from bottom and top of the door.
5 cm 1 cm 1 cm
Loading ...
Loading ...
Loading ...