Loading ...
Loading ...
Loading ...
Page 10
CUTTING PREPARATION
Before you start to cut, make sure that you
• Wear heavy gloves for maximum grip and
protection.
• Maintain a proper grip on the machine
during operation.
• Use your right hand grip on the rear
handle while your left hand grip on the
pole shaft.
• Keep your body to the left of the chain
line.
• Never use a left-handed (cross-handed)
grip, or any stance that places your body
or arm across the chain line.
• Never stand directly under the limb you
are cutting.
• Periodically examine the tightness of the
collars during operation.
INSTALL THE BATTERY PACK
WARNING
• If the battery pack or charger is damaged,
replace the battery pack or the charger.
• Stop the machine and wait until the motor
stops before you install or remove the
battery pack.
• Read and understand the instructions in
the battery and charger manual.
To install the battery pack
1. Align the lift ribs on the battery pack with
the grooves in the battery compartment.
2. Push the battery pack into the battery
compartment until the battery pack locks
into place.
3. When you hear a click, the battery pack is
installed.
To remove the battery pack
1. Push and hold the battery release button.
2. Remove the battery pack from the ma-
chine.
ASSEMBLY
ADD THE BAR AND CHAIN
OIL
Examine the amount of oil in the machine. If
the oil level is low, add the bar and chain oil
as follows.
IMPORTANT: Use bar and chain oil that is
only for chains and chain oilers.
NOTE: The machine comes from the factory
without bar and chain oil.
1. Loosen and remove the cap from the oil
tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator to make sure that
no dirt gets into the oil tank while you add
the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. The whole oil tank will last for approximately
15 - 40 minutes.
IMPORTANT: Do not use dirty, used or
contaminated oil. Damage can occur to the
bar or chain.
FIG. 4
Oil
Oil Tank
Oil Indicator
FIG. 5
Loading ...
Loading ...
Loading ...