Loading ...
Loading ...
Loading ...
PelPro Pellet Stove • 7083-801C • October 28, 2019 pelprostoves.com
28
Replacement Parts
Replacement Parts
REV
REVISIONS
A RELEASED
1
Zone
1
Zone
2
Zone
2
Zone
3
Zone
3
Zone
Control Board
1. Turn the dial control to the off position. Unplug the
power to the unit.
2. Unplug the wires from the control board. The
connectors are locking connectors. Pinch the release
tab on each connector and gently tug and rock loose.
3. Pinch the 4 plastic pins from the rear of the unit
with needle nose pliers to release the control board
connectors.
4. Install new board following the steps in reverse.
Replacement kit: SRV7103-050
Feed Motor Assembly
1. Turn the dial control to the off position and unplug the appliance. Remove the right side panel
and feed motor cover plate in the rear of the appliance.
2. Remove the 4 screws and cover plate.
3. Remove remaining pellets in feed assembly.
4. Unplug feed motor from wire harness.
5. Remove silicone from around bushing end cap. Using Phillips head screwdriver remove 2
screws retaining the end cap to the feed tube.
6. From inside the hopper, lightly tap on the end cap alternating side to side to remove feed
assembly from feed tube.
7. Re-install new feed assembly in reverse order; ensuring that the top of the feed bushing
is in place and the bushing end cap is symmetrical in the feed tube chamber prior to nal
tightening of the retaining screws. Silicone the end cap to the feed tube.
8. Plug the feed motor leads back in and restore power.
Replacement kit: SRV7077-014
Loading ...
Loading ...
Loading ...