Loading ...
Loading ...
Loading ...
ENGLISH
|
7
Using Your JULE
Steam Jewelry Cleaner
FILLING BOILER WITH WATER
1. Place JULE Steam Jewelry Cleaner on a at, level surface.
2. Make sure power cord is unplugged from electrical outlet.
3. Cautiously remove Boiler Cap by unscrewing it in a counter-clockwise direction and lift off.
CAUTION: Refer to relling procedures below for additional safety precautions that must
be taken when relling the unit after it has been in use.
4. Boiler should always be emptied after each use. If it was not emptied after the previous use,
empty it now – this will make it easier to ll with the correct amount of water.
5. Fill included Measuring Cup with 12 oz (355 ml) of water.
NOTE: In order to extend the life of your JULE Jewelry Steam Cleaner and keep it
functioning at its maximum potential, it is highly recommended that distilled or de-
mineralized water be used in the Boiler.
6. Carefully pour water from Measuring Cup into Boiler through ll hole.
NOTE: Do not exceed the Boiler’s maximum capacity of 12 oz (355 ml). This will ensure a
better ow of steam with minimal dripping water.
7. Replace Boiler Cap, screwing it in a clockwise direction to tighten. Make sure it is screwed
on securely to prevent hot water or steam from escaping.
RE
FILLING THE BOILER
WARNING: If unit has been in use, always use the following safety precautions before
removing the Boiler Cap to add water.
•
Allow unit to cool for 30 minutes.
•
Press and hold Steam Button to release all remaining steam. Steam can remain
pressurized inside Boiler for up to an hour after use.
WARNING: Failure to follow these precautions may result in burns from escaping steam
when the Boiler Cap is removed.
Loading ...
Loading ...
Loading ...