Loading ...
Loading ...
2. CONTENTS
- 3 -
- 10 -
Depending on manufacture and model, some engine components do change. Please check with
Autodata or the manufacturer’s data before use.
1. TITLE PAGE
1.1 INTRODUCTION.......................................................................................................... 2
1.2 REVISION HISTORY .................................................................................................. 2
1.3 UNDERSTANDING THIS GUIDE................................................................................. 2
1.4 COPYRIGHT NOTICE .................................................................................................2
2. CONTENTS
2.1 CONTENTS ....................................................................................................................3
3. GUARANTEE
3.1 GUARANTEE ............................................................................................................... 4
4. GENERAL PRODUCT INFORMATION
4.1 GENERAL PRODUCT INFORMATION ....................................................................... 5
5. HEALTH AND SAFETY INFORMATION
5.1 GENERAL SAFETY INSTRUCTIONS FOR USE
Personal safety........................................................................................................... 6
6. CONTENTS
6.1 PARTS DRAWING AND LISTING ............................................................................... 7
7. APPLICATION
7.1 PRODUCT APPLICATION AND COMPATIBILITY LISTING ...................................... 8
8. PREPARATION
8.1 ADVISORIES BEFORE USE ...................................................................................... 9
9. PROCEDURE AND APPLICATION GUIDE
9.1 APPLICATION GUIDANCE........................................................................................10
10. EXPLANATION OF SYMBOLS
10.1 EXPLANATION OF SYMBOLS .................................................................................. 11
9. PROCEDURE AND APPLICATION GUIDE
Please note images are for guidance only and subject to change.
Component 1
Component 1 is designed to be used with a ½” drive
breaker bar to hold the camshaft pulleys while the
camshaft pulley fixings are removed.
Component 2
Component 2 has been designed to fit as shown in the
diagram to lock the balance shaft in its timed position.
Ensure the engine is at TDC and appropriate locking tools
have been used to lock the camshafts and crankshaft in the
relative positions. The balancer shaft locking tool locates
at the rear of the balance shaft.
Component 3
Component 3 is used to remove the camshaft sprocket
hubs when dismantling the cylinder head or timing the
inlet and exhaust camshafts. Ensure the hub fixing bolt
is left loose in place for the puller to push against.
Loading ...
Loading ...
Loading ...