Loading ...
Loading ...
ASSEMBLY INSTRUCTIONS (continued)
1. Install the mounting strap (BB)
to the outlet box with the
stamped word “FRONT” facing
away from the outlet box,
using two mounting screws
(AA) that best fit the outlet box.
(Choose one matching pair of
suitable mounting screws (AA)
from the 3 pairs provided).
2. Thread the fixture wires
through gasket (FF), then
attach the gasket (FF) into
backplate (A) of the light
fixture.
4. Attach the backplate (A)
of the light fixture to the
mounting strap (BB), then
secure it with the fixture
mounting screw (DD).
Push the decorative
cover (CC) firmly into the
fixture mounting screw
hole on the light fixture.
Page 3 of 4
201015
Outlet Box
1
BB
AA
5. With silicone caulking compound (not included), caulk completely around where the
backplate (A) meets the wall surface.
CAUTION: Be sure to caulk completely where the backplate meets the wall
surface to prevent water from seeping into the outlet box and light fixture.
Adjusting the Light Head:
A
5
1. Gently grasp the light heads and move them up or down, left or right
to adjust the light coverage area.
Keep the light heads face down around 30 degrees angle to avoid
water damage and electrical shock (See Fig.1) .
Fig.1
Fig.2
CCT
2700K 5000K
Turn off the power at fuse or circuit box.
Turn on the power at fuse or circuit box.
4
B
A
DD
BB
CC
FUNCTION AND OPERATION
A
2
B
FF
EE
3
3. Connect the house grounding
wire and the fixture grounding
wire (green) using the wire
connector (EE).
Connect the fixture black wire
to the house black wire and
the fixture white wire to the
house white wire using wire
connector (EE) provided.
Carefully tuck the wires back into the outlet box.
1. Wall switch control.
Turn on the wall switch to switch on the light.
2. CCT color
You can adjust the “CCT color” (2700K~5000K) by CCT color switch
on the backplate.
3. Low level Brightness Setting
Turn the wall switch "OFF" and turn it "ON" twice within 3 seconds, the
light will go into low-level brightness and predetermined CCT color.
To revert back to default,turn the wall switch "OFF"and then turn it "ON" over 5 seconds again.
Loading ...