OWNER’S MANUAL
260-2015
PREMIUM SHOP STOOL
DO NOT RETURN TO STORE
For Customer Service:
Email: [email protected]
Phone: 1-877-898-3958
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.
UNPACKING AND INSPECTION
SPECIFICATIONS
WARNING: DO NOT operate this stool if damaged during shipment, handling, or misuse. Do not
operate the stool until the parts have been replaced. Failure to do so may result in serious personal
injury or property damage. All damaged parts must be repaired or replaced as needed prior to operating
this stool. Check to see that all nuts, bolts, and fittings are secure before using this product.
Capacity:....................................................................................................................................... 300 lbs.
Assembled Dimensions:......................................................................... 26" - 31-1/2" H x 16" W x 16" D
(67 - 81cm x 41cm x 41cm)
Seat:............................................................... 360 Degree Swivel, 16" Diameter with 4" High Seat Back
Seat Height:.......................................................................................................................... 22-1/2" - 28"
SPECIFIC WARNINGS
Maximum weight capacity is 300lbs/136kg. Do not stand on stool or use the stool as ladder. Do not sit
on the backrest or edge of the stool. For indoor use only. The stool must be on a level surface for proper
stability. Only use the stool when fully assembled. Failure to follow warnings can cause serious injury.
1
1. DO NOT exceed rated capacity. Overloading the stool can cause damage to or failure of the stool.
2. Use only on a hard, level surface capable of sustaining the load. Use on uneven or yielding
surfaces can result in stool instability.
3. DO NOT stand on stool. Serious injury may occur.
4. DO NOT expose to heat. Parts of the unit are under pressure.
5. DO NOT alter this product in any way.
6. Keep your work area clean and well lit. Cluttered work areas invite accidents.
7. Store idle stool out of reach of children.
8. Stool service must be performed only by qualified repair personnel. Service or maintenance
performed by unqualified personnel could result in a risk of injury.
9. When servicing a stool, use only identical replacement parts - refer to attached, product-specific
parts list and diagram. Use of unauthorized parts may create a risk of injury.
10. The warnings, precautions, and instructions discussed in this manual cannot cover all possible
conditions and situations that may occur. The operator must understand that common sense and
caution are factors, which cannot be built into this product, but must be supplied by the operator.
IMPORTANT SAFETY INFORMATION
!
WARNING: READ, UNDERSTAND, AND FOLLOW ALL INSTRUCTIONS AND WARNINGS
BEFORE USING THIS PRODUCT. FAILURE TO DO SO MAY RESULT IN PERSONAL INJURY
AND/OR PROPERTY DAMAGE.
!
PACKAGING CONTENTS
Seat Cushion with
Lifting Lever
Cylinder Base
ASSEMBLY INSTRUCTIONS
Note: No tools are required for assembly, but inspect components for proper fit and alignment
before assembling. Tighten any loose fasteners. Do not use if any parts are damaged or missing.
1. Place the base on a solid surface and insert the wider end of the pneumatic cylinder into the opening
in the center of the base.
2. Carefully, position the seat assembly over the center rod in the pneumatic cylinder and press down.
3. Ensure all three pieces have properly seated and fit together tightly. You should now be able to lift
the seat up by the cushion without it coming off the pneumatic cylinder. If the seat comes off, repeat
steps 2 and 3.
Step 1
Step 2
Step 3
PRESS
16" / 41cm
22-1/2" / 56 cm
28" / 71 cm
Press seat lever
to raise and
lower seat.
2
