Loading ...
Loading ...
Loading ...
Page 9
START / STOP THE BLOWER
To start
1. Press and hold the safety lock button.
2. Squeeze the trigger to start the machine.
3. Release the trigger to decrease the speed.
4. Release the lock-out button. The hedge
trimmer will stay on as long as the trigger
switch is engaged.
To stop
1. Release the trigger to stop the machine.
IMPORTANT: If the hedge trimmer is
accidentally dropped, the hedge trimmer will
turn OFF and the blade will coast to a stop
after several seconds. The hedge trimmer will
then be locked OFF again.
FIG. 5
Safety lock button
Auxiliary
handle
Trigger
ROTATE THE REAR HANDLE
1. Place the hedge trimmer on a flat and even
surface.
2. Make sure that you released the trigger.
3. Pull the rotation lever and begin turning the
rear handle. Release the rotation lever and
turn the handle 90 degrees to either side
until it clicks into place and the lever locks
in.
4. To turn the handle back to center, pull the
rotation lever again, turn the handle slightly,
release the rotation lever and continue
turning the handle until it locks into place.
FIG. 6
Rotation lever
OPERATION TIPS
• Do not push the machine through heavy
shrubbery. This can cause the blade
blockage. If the blades blocks,
1. stop the machine.
2. remove the battery pack.
3. remove the blockage.
• Do not try to cut too large stems or twigs.
• Wear the gloves when you cut.
• Cut the new growth with a wide sweeping
action so that the stems are put directly into
the blade.
• You can use a string to adjust the height of
the hedge.
• Stretch a piece of string along the hedge
at this height.
• Cut the hedge immediately above this
string.
• Cut the side of a hedge until it will be
narrower at the top. More of the hedge
will come into view in that way.
OPERATION
Loading ...
Loading ...
Loading ...