Loading ...
Loading ...
Loading ...
34
Operation
Features
Your garage door opener is equipped with features to provide you with greater control over your garage door
operation.
myQ
®
The Wi-Fi Garage Door Opener is compatible with up to 16 myQ
®
enabled accessories. Up to 10 devices can be
paired to the Wi-Fi garage door opener’s internal gateway. These devices can be controlled with the myQ
®
App.
These devices include any combination of myQ
®
garage door openers, Wi-Fi garage door openers, and myQ
®
light
controls. Up to 6 devices can be paired to garage door opener itself (controlled by garage door opener through
900MHz). These devices include any combination of myQ
®
light controls or a garage door and gate monitor.
TIMER-TO-CLOSE (DO NOT enable on one-piece doors)
The Timer-to-Close feature is not available on all door controls. Below is a list of door controls with the Timer-to-
Close feature:
041A7305-1 Smart Control Panel and 041A7327-1 Motion Detecting Control Panel
The Timer-to-Close feature automatically closes the garage door after a specified time period. DO NOT enable TTC
if operating a one-piece door. TTC is to be used ONLY with sectional doors. Factory default is set to off. The
garage door opener will beep and the lights will flash before closing the door. The TTC feature will deactivate if the
garage door encounters an obstruction twice; or the safety reversing sensors are incorrectly installed. The garage
door will reverse open and WILL NOT close until the obstructions are clear or the safety reversing sensors are
correctly installed. When the obstruction has been cleared or the safety reversing sensors have been aligned, the door
will close when the garage door opener is activated. TTC WILL NOT work if the garage door opener is operating by
battery power or if the safety reversing sensors are misaligned. This feature is NOT intended to be the primary
method of closing the door. A keyless entry should be installed in the event of an accidental lock out when
using this feature.
REMOTE CONTROLS ANDDOOR CONTROLS
Your garage door opener has already been programmed at the factory to operate with your remote control, which
changes with each use, randomly accessing over 100 billion new codes.
myQ
®
Accessories
MEMORY CAPACITY
Remote Controls Up to 8
Door Controls
Up to 2 myQ
®
door controls
Keyless Entries Up to 1
THE PROTECTOR SYSTEM
®
(SAFETY REVERSING SENSORS)
When properly connected and aligned, the safety reversing sensors will detect an obstruction in the path of the
infrared beam. If an obstruction breaks the infrared beam while the door is closing, the door will stop and reverse to
full open position, and the opener lights will flash 10 times. If the door is fully open, and the safety reversing sensors
are not installed, or are misaligned, the door will not close from a remote control. However, you can close the door if
you hold the button on the door control or keyless entry until the door is fully closed. The safety reversing sensors do
not effect the opening cycle.
ENERGY CONSERVATION
For energy efficiency the garage door opener will enter sleep mode when the door is fully closed. The sleep mode
shuts the garage door opener down until activated. The sleep mode is sequenced with the garage door opener light
bulb; as the light bulb turns off the sensor LEDs will turn off and whenever the garage door opener lights turn on the
sensor LEDs will light. The garage door opener will not go into the sleep mode until the garage door opener has
completed 5 cycles upon power up.
LIGHTS
The garage door opener light bulbs will turn on when the opener is initially plugged in; power is restored after
interruption, or when the garage door opener is activated. The lights will turn off automatically after 4-1/2 minutes. An
incandescent A19 light bulb (100 watt maximum) or for maximum energy efficiency a 26W (100W equivalent) compact
fluorescent light (CFL) bulb may be used. NOTE: Do not use halogen, short neck, or specialty light bulbs as these
may overheat the end panel or light socket. Do not use LED bulbs as they may reduce the range or performance of
your remote controls.
Light Feature
The garage door opener is equipped with an added feature; the lights will turn on when someone enters through the
open garage door and the safety reversing sensor infrared beam is broken.
Loading ...
Loading ...
Loading ...