Loading ...
Loading ...
Loading ...
Page 11
Error Codes and Protection Code:
EH60 -
P2 - Bucket has reached the set Fill
Level– Empty the bucket and place
the unit on the bucket properly.
Eb - Bucket is removed or not in right
position - Replace the bucket in
the right position. (only available
for the unit with pump feature.)
Auto Defrost
When frost builds up on the evaporator
coils, the compressor will cycle off
and Auto Defrost function will run
automatically.
3 minute compressor operation delay
protection
After the unit has stopped, it can not be
restarted in the first 3 minutes to protect
compressor operation. The unit will
restart automatically after 3 minutes.
Auto-Restart
If the unit stops unexpectedly due to
power being cut, it will restart with
the previous function setting (except
bucketless mode) automatically when
the power resumes.
Timer Function
• When activating the Timer function, you
are setting the time until the unit changes
its power state. This means, if the unit is
on, activating the timer function will set
the time until the unit will turn off. If the
unit is off, activating the timer function
will set the time until the unit will turn on.
• The time can be set after pressing the
timer button then using the up or down
buttons. These buttons will change
the time in 0.5 hour increments up to
10 hours. After 10 hours, the time will
change in 1 hour increments up to 24.
• If an error code appears during this time,
the timer function will be cancelled.
NOTICE
• When first using the dehumidifier,
operate the unit continuously 24 hours.
Make sure the plastic cover on the
continuous drain hose outlet is installed
properly so there are no leaks.
• This unit is designed to operate in a
working environment between 5°C/41°F
and 35°C/95°F.
• Make sure the water bucket is
positioned correctly so that the unit
can operate properly. When the water
in the bucket reaches a certain level,
please be careful while moving the unit
to avoid spilling.
Other Features
Operating
Instructions
Room temperature r sensor
error--Unplug the unit and plug
it back in. If error repeats, call
for service.
EH61 -
Tube Temperature sensor of
the evaporator error--
Unplug the unit and plug it
back in. If error repeats,
call for service.
EH0b -
Display board and master
control board communication
error.Unplug the unit and plug
it back in. If error repeats, call
for service.
Loading ...
Loading ...
Loading ...