Loading ...
INSTALLATION AND OPERATION INSTRUCTIONS
INSTALLATION
·
Gently remove all parts from the package and lay them out on a smooth surface.
1. Remove the mount bracket
from the light, and use your
finger to push up on the mount
bracket. Then slide the bracket
down off the back of the light.
2. Open the battery case cover
by loosening the screw
(anticlockwise) of the
battery case cover.
3. Insert three D size batteries
(not included). Then close the
battery case cover and screw
it tightly(clockwise).
4. If mounting to wall or brick,
drill two suitable holes using
power drill (not included) into
the mounting surface. Use
attached two screws and two
anchors to fix the mount
bracket on the wall.
5. Line up the light fixture with
themount bracket and slide the
light into the grooves.
2
OPERATIONAL INSTRUCTIONS
1. Adjust the head of light fixture toward to left or right direction to get the desired light direction.
2. Adjust the head of light fixture toward to up and down to get the desired light direction.
3. Slide the switch to Auto from OFF position to power on the light.
When power is on, the PIR sensor enters a “warm-up” period for about 15 seconds, then automatically switches into AUTO MODE.
If needed, gently grasp the lamp heads and tilt or rotate them to adjust the light coverage area.
NOTE: Light sensor only allows light to activate in darkness. We recommend you to test in a dark room or closet.
Sensor Range: Up to 9 m / 30 ft. x 160 degree spread (Varies with various environment).
Auto Shut-off: Light shuts off automatically after around 20 seconds if no motion is detected.
Lumens output: 1,000 lumens / 5,000K (Max, use new Duracell D size battery).
BATTERY REPLACEMENT
Use only new alkaline D size batteries with 1.5V rating for replacement.
Note: Replace batteries around every four months.
·
Non-rechargeable batteries are not to be recharged.
·
Do not mix old and new batteries.
·
Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
·
Exhausted batteries are to be removed from the product.
·
Do not dispose of batteries in fire.
·
Batteries should be recycled or disposed of as per state and local guidelines.
·
Batteries are to be inserted with the correct polarity.
Note: While the batteries are exhausted the light will not turn on. If you slide the switch to OFF and back to AUTO again the light will enter a “warm-up” period for about
15 seconds.
TROUBLESHOOTING
The light does not come on
√ Check the battery and make sure that it has contact to the metal plate and the polarity is correct.
If the battery is worn out, replace the battery with three new D size batteries.
Light sensor only allows light to activate in darkness.
Questions, problems, missing parts?
Before returning to your retailer, call our customer service at 855-232-6423
Monday – Friday 8:00 a.m. – 8:00 p.m. (EST)