Loading ...
Loading ...
Loading ...
6
EVERY 3 MONTHS - Check Lubricant Oil
The seals are bathed in 250 cc (8.5 fl. oz.) of oil that is safe for water and fish.
1. Make sure pump is horizontal.
2. Locate the oil port (Figure 3).
3. Using a 6 mm Allen wrench, remove the screw and rubber washer.
4. Drain a little oil from the oil port.
a. If oil appears to be milky in color, this means water is present.
b. The oil can be replaced with basic vegetable oil. See below diagrams on changing the oil.
Replacing Lubricant Oil
1. Make sure pump is horizontal.
2. Locate the oil port (Figure 3).
3. Using a 6 mm Allen wrench, remove the screw and rubber washer..
4. Drain oil from the oil port.
5. Using an oil can with 250 cc (8.5 fl. oz.) of any common vegetable oil, place the new oil in the pump
(Figure 4).
6. Tighten the screw and rubber washer back in the oil port.
WARNING: Do not overfill the oil chamber, as this can create a dangerous hydraulic pressure. Overfilling
voids the warranty.
Figure 3
Figure 4
EVERY 18 MONTHS – Replace the motor seals
The seals prevent water from entering the motor, but over time, they can become worn. Please call
1-844-251-7445 to order a replacement seal kit.
NOTE: The seals must be replaced before failure. If the seals fail, the motor could be permanently
damaged.
Please register your pump online so we can remind you to order seals. Go to
www.watersourceusa.com/registration to register your pump.
Loading ...
Loading ...
Loading ...