Loading ...
Loading ...
Loading ...
LIGHTING:
2. Fully open the LP cylinder valve.
Note: If the ame does not light or goes out, repeat Step 3.
WARNING: FOR YOUR SAFETY: If at any time you are unable to light the burner and smell gas, wait 5 minutes to allow gas
to dissipate before attempting to light heater. If after 1 minute, you are unable to light burner, wait 5 minutes and allow
NOTE: If a new tank has just been connected, please allow at least one minute or more for the air in the gas line to purge
out through the hole, or simply complete Step 3. When lighting the heater make sure that the control knob is continuously
depressed while pressing the igniter button. Control knob can be released after the ame has been lit for 20~30 seconds.
Flame can be watched and checked from the peephole located on the base of burner. If the ame does not light or it goes
out, repeat Step 3. If the burner ame goes out accidentally or it is blown out by wind, turn off the heater and wait at least 5
minutes or more to let the gas dissipate before relighting to avoid possible gas explosion. Repeat steps as listed above.
TO TURN OFF THE HEATER
1. Turn the control knob to "HI" position.
2.
3. Turn the gas cylinder valve to OFF or CLOSED and disconnect the cylinder.
If you experience any ignition problems, please consult the “Troubleshooting” section of this manual.
Caution: Avoid inhaling fumes emitted from the heater’s rst use. Smoke and
odor from the burning of oils used in the manufacturing will appear. Both smoke
and odor will dissipate after approximately 30 minutes. The heater should NOT
produce thick black smoke.
WHEN HEATER IS ON:
Emitter screen will become bright red due to intense heat. The color is more visible
the
section of this manual
RE-LIGHTING:
2. Wait at least 5 minutes to allow gas to dissipate before re-lighting.
WARNING
Be careful when attempting to manually ignite
OPERATING INSTRUCTIONS
Contact us for assistance: [email protected]
Loading ...
Loading ...
Loading ...