Loading ...
Loading ...
Loading ...
9
Customer Service: 1-877-777-8042
3
QUICK START GUIDE
HOW TO
VACUUM AND SEAL A BAG
When the Red Seal light
turns off, the vacuum seal
process is complete, the
Vacuum View Window will
release and the sealed
bag is ready for storage.
2
With the bag in place,
PUSH and RELEASE the
Vacuum and Seal Bar
(I) with both hands. The
Vacuum View Window
will automatically close
and grasp the bag, which
begins the vacuum and
seal process.
1
With both hands,
INSERT the open
end of the bag
through the bottom
of the Vacuum View
Window (C) into
Drip Tray (L)
(C)
IMPORTANT TIP:
The
Vacuum View Window
allows you to easily see
where to insert the end of
the bag into the drip tray,
before activating the
vacuum and sealing bar
IMPORTANT TIP:
When Dry and
Moist lights flash, the drip tray is
full. Please empty it. Vacuum
and Seal function will begin
again after drip tray is emptied.
CAUTIONS: 1. Do not put
fingers or any foreign objects
inside of Vacuum View
Window while vacuum sealing.
2. Lid closes down
automatically with force.
Do not obstruct the lid from
closing. Do not manually force
the lid to close.
Use the PulseVac™ Control feature to
manually control the vacuum process and
avoid crushing delicate items.
1. Place item(s) in bag, allowing at least
three inches (7.62 cm) of space between
bag contents and top of bag.
2. Press the PulseVac™ button. This will
cause the “Vacuum” light to illuminate.
3. Insert open end of the bag into the
Vacuum View Window until it is just inside
of the drip tray. Then Press Seal activation
bar to close the window.
4. Press the PulseVac™ Button. The vacuum
pump will run when the PulseVac™ Button
is held down. Release the PulseVac™
Button to stop the vacuum process. This
will allow you to adjust the contents of
the bag for better control of the vacuum
sealing process. Repeat pushing the
PulseVac™ Button until desired amount of
air has been removed.
NOTE: If the vacuum pump stops engaging after several
pushes of the PulseVac
™
Button, it means the maximum
vacuum has been reached. Do not continue to push the
PulseVac
™
Button. The bag will be sealed automatically if
you reach max vacuum.
5. Press Seal Button to seal the bag and end
the PulseVac™ mode.
6. When the red Seal Indicator light turns
off, remove bag. Refrigerate or freeze if
needed.
Use PulseVac
™
Control Feature
(I)
(I)
Loading ...
Loading ...
Loading ...