Loading ...
Loading ...
Loading ...
WARNING: THIS APPLIANCE MUST BE EARTHED
The use of an extension lead or multi-plug adaptor is
not advised when connecting this product to the mains.
Connection through these devices could lead to risk of
overloading, overheating and even fire at the extension
lead or adaptor due to inadequate connection quality
This heater must be used on an AC (~) supply only and
the voltage marked on the heater must correspond to
the supply voltage. This heater is fitted with a rewirable
plug incorporating a 10/13 amp fuse. In the event of
replacing the fuse in the plug supplied, an equivalent
10/13 amp fuse approved by ASTA to BS 1362 must
be used. If any other type of plug is used, a 15 amp
fuse must be fitted in the plug, the adaptor, or at the
distribution board.
IMPORTANT: If the plug is not suitable for your socket,
the 13 amp plug should be removed. Before wiring
the appropriate plug, please note that the wires in
this mains lead are coloured in accordance with the
following code:
GREEN AND YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
Connect the GREEN AND YELLOW wire to the
terminal marked ‘E’ or by the earth symbol , or
coloured GREEN or GREEN AND YELLOW. Connect
the BROWN wire to the terminal marked ‘L’ or coloured
RED. Connect the BLUE wire to the terminal marked
‘N’ or coloured BLACK.
General
The heater is designed for operation on an AC
electricity supply, and is suitable for use in domestic
dwellings and similar indoor locations.
The heater is supplied with feet and handles for ease
of movement. An electronic control provides the
ability to choose an available heat output and control
the room temperature. It is supplied with a cord and
plug and is ready for use once the feet have been
correctly fitted.
Electrical Connection Assembly and Positioning
The ML Convector can only be used as a portable
heater.
To install the feet,
lay the heater on its back and remove
the two foot fixing screws, highlighted in Fig. 2. Assemble
the feet by pressing them firmly into the convector body
as indicated in Fig. 2, the foot should clip into position.
Secure using the foot fixing screw, Return the convector to
the upright position,
The appliance is now ready for use.
Always ensure that the heater is stood on a firm,
level base near to, but not directly underneath a
suitable mains supply socket.
Ensure that curtains and furniture are not positioned
close to the chosen position.
If young children, the aged or infirm are likely to
be left in the vicinity of the heater, we advise that
the adequate precautions should be taken. We
recommend that a guard be fitted to ensure contact
with the heater is avoided and objects cannot be
inserted into the product.
WARNING: PLEASE ENSURE THE MINIMUM CLEARANCE
DIMENSIONS INDICATED IN Fig.1 ARE MAINTAINED
WARNING: The heater must only be operated with
the feet securely fitted and in the upright position.
Never use the heater as a portable appliance without
the feet securely fitted using the screws provided.
Fig. 2
Operation
IMPORTANT - OBJECTS OR CLOTHING MUST NOT
BE PLACED ON THIS HEATER.
Before using the heater ensure that all warnings and
instructions have been carefully read.
To activate the heater, after installation or assembly,
simply plug it in.
Note: The element has been coated with a protective
film which will burn off during the first few minutes
of use, this may cause a small amount of fuming.
This is quite normal – the fumes are non-toxic and
will quickly disappear.
We recommend that you open a window to ventilate
the room when using the heater for the first time.
Loading ...
Loading ...
Loading ...