Loading ...
Loading ...
Loading ...
21
EN
MOUNTING
Wall mounting
• Do not connect the appliance to the mains until properly xed to the wall and the
instructions are read fully.
• The minimum distances must be observed in the diagrams on the right.
• For installation of the appliance, care must be taken not to damage concealed
cables.
• Please be careful whilst drilling holes.
• This appliance is designed to be permanently xed to a wall at a minimum height
of 300 mm.The wall bracket must be tted horizontally and the cable routed to the
bottom right of the heater.
Figure 1: A distance of 600mm from
bottom of heater to oor is recommended
for optimum viewing of fuel bed; see
Fig.1 for recommend xing dimensions.
Figure 2: For optimum viewing, mark the
top ve screws xing positions on wall in
accordance with the recommend xing
dimensions
Ensure that the bracket is level by using a Spirit level whilst marking out the hole
positions. Drill holes with a No. six drill bit. Fix the wall bracket using that the plug
and screws provided. Attach the lower xing bracket the base of the re using the two
small black screws supplied; ensure the bracket is tted so that it is level with the back.
Carefully lift the heater up ensuring that the top rear ledge of heater engages with the
wall bracket (see Fig.2 in circle) and is sitting centrally. This process should be carried
out by two people to avoid injury or damage to property or the appliance. Gently bring
the heater down against the wall.
Loading ...
Loading ...
Loading ...