Loading ...
Loading ...
Loading ...
13
Care and Maintenance
Storage
1. When the pressure washing session is complete,
turn o the power switch.
2. Unplug the power cord from the outlet.
3. Turn o the water supply. Pull the trigger on the
spray gun 2-3 times to drain out excess water and
to release any remaining water pressure.
4. Disconnect the garden hose adapter from the
water inlet. DO NOT allow the power washer to run
with no water owing through it.
5. It is recommended to run pump saver through the
pump and high pressure hose.
5a. Install the pump saver by attaching the bottle
to the garden hose adaptor and open the
valve on the bottle.
5b. Plug in the power-cord and turn the pressure
washer on/o switch to the “ON” position
and pull the trigger for 5 seconds in order to
activate the pump and purge the pump saver
through the pump system and hose.
5c. Once you are done, turn the on/o switch to
the “OFF” position, pull the trigger to release
the internal pressure and then disconnect the
hose and accessories from the power washer.
6. Remove hose from spray gun.
7. Remove lance from spray gun. Place the gun in
the holder on the side of the unit. Place lance into
any of the slots in the back of the unit.
8. Hook the power cord around the power cord
holder.
Loading ...
Loading ...
Loading ...