Loading ...
Loading ...
Loading ...
2. Attach direct wire cable
to strain relief
tI_t--
_jJ_
__ m
Put direct wire cable through the strain relief. The strain
relief should have a tight fit with the dryer cabinet and be
in a horizontal position. Tighten strain relief screw against
the direct wire cabJe.
if your wiring looks like this:
4-wire direct connection:
Go to "4-Wire Direct Connection"
on this page.
3-wire direct connection:
_2_ Go to "3-Wire Direct Connection".
4-wire Direct Wire Connection
iMPORTANT: A 4-wire connection is required for mobile homes
and where local codes do not permit 3-wire connections.
2. Prepare to connect neutraJ
ground wire and neutral wire
Remove center terminal block screw (B). Remove neutral
ground wire (E) from external ground conductor screw (A).
3. Connect neutral ground wire
and neutraJ wire
E C
. Prepare your 4-wire cable for
direct connection
(/27
/
Direct wire cable must have 5 ft. (1.52 m) of extra length
so dryer may be moved if needed.
Strip 5" (127 mm) of outer covering from end of cable,
leaving bare ground wire at 5" (127 mm). Cut 11/2'' (38 mm)
from remaining 3 wires. Strip insulation back 1" (25 mm).
Shape ends of wires into hooks.
onncnerronwrneI
hooked end (hook facing right) of neutral
wire (white or center wire) (C) of direct wire
cable under center screw of terminal block
(B). Squeeze hooked ends together and
tighten screw.
E F
Connect ground wire (green or bare) (F) of direct wire cable
to external ground conductor screw (A). Tighten screw.
14
Loading ...
Loading ...
Loading ...