Loading ...
Loading ...
Loading ...
en Appliance door
24
Fitting the pull-out rails
The rails are designed to fit on either the right- or the
left-hand side (not both).Make sure when you fit them
that you can pull them out towards you.
1. The rail must sit between the two bars (fig. !).
2. Push the retainer at the back in between the lower
and the upper bar (fig. ").
3. Push on the "PUSH" tab and swing the rail in so that
the retainer ends up between the two bars (fig. #).
4. Release the "PUSH" tab; the retainer will hook into
place (fig. $). Then pull the rail out as far as it will go
and slide it back in.
qAppliance door
Ap p l i a n c e door
With good care and cleaning, your appliance will retain
its appearance and remain fully functional for a long
time to come. This will tell you how to remove the
appliance door and clean it.
Removing and fitting the appliance door
To clean the door panels, you can detach the appliance
door.
:Warning – Risk of injury!
The hinges of the appliance door may snap shut with
great force. Always fully turn the two locks for fitting and
removing the appliance door.
:Warning – Risk of injury!
If the appliance door has been removed without turning
both locking levers to their limit stops, the hinge may
snap shut. Do not reach into the hinge. Call the after
sales service.
Detaching the appliance door
1. Open the left- and right-hand door locks (fig. !).
To do this, hold the screwdriver horizontally and use
it to push the door lock (black component) on each
side of the door all the way up (fig. ").
Tip: Use a torch to light up the gap so that you can
see the door locks.
Door lock closed (fig. #)
Door lock open (fig. $)
1
2
2
1I
Loading ...
Loading ...
Loading ...