Loading ...
Loading ...
Loading ...
• Your machine’s door is open, shut the door
to continue.
If the program won’t start
• Check if the plug is connected.
• Check your indoor fuses.
• Check that the water inlet tap is turned on.
• Check that you have closed the machine door.
• Check that you switched off the machine by
pressing the power on/off button
.
• Check that the water inlet filter and the machine
filters are not clogged.
If the control light is off after a wash operation
• The power on/off button isn’t released yet.
If detergent residues are left in the detergent
compartment
• Detergent has been added when the detergent
compartment was wet.
• Large dishes have blocked the dispenser door.
If water is left inside the machine at the end of the
program
• The water drain hose is clogged or twisted.
• The filters are clogged.
• The program is not finished yet.
TIPS & INFORMATION
IMPORTANT
At the end of the program, water may still remain on the
sides and door of the appliance.
If the machine stops during a wash operation
• Power failure.
• Water inlet failure.
• Program is on standby mode.
If shaking and hitting noises are heard during
a wash operation
• Dishes are placed incorrectly.
• The spray arm is hitting the dishes.
If there are partial food wastes left on the dishes
• Dishes are placed incorrectly into the machine,
sprayed water did not reach related places.
• Basket overloaded.
• Dishes leaning against one another.
• Very small amount of detergent added.
• An unsuitable, rather weak wash program selected.
• Spray arm clogged with food waste.
• Filters clogged.
• Filters incorrectly fitted.
• Water drain pump clogged.
If there are white stains on the dishes
• A very small amount of detergent is being used.
• Rinse aid dosage setting at a very low level.
• Water hardness is very high.
If the dishes won’t dry
• A program without a dry operation selected.
• Rinse aid dosage set too low.
• Dishes unloaded too fast.
• Use a hotter program.
If there is rust on the dishes
• Stainless-steel quality of the dishes washed
is insufficient.
• High level of salt in the wash water.
• Unhealthy mains grounding.
Unloading the baskets
• For improved drying results with the most effective
use of energy, open the door approximately 10cm at
the end of the program.
• Allow the tableware to cool for 30-40 minutes as hot
items can easily be damaged.
• First remove items from the lower basket before
removing the items from the upper basket.
Call an authorised service if the problem still
persists after the controls or in case of any
malfunction not described above.
Useful Information
• Whenever you will not be operating your machine:
- Unplug the machine and then turn water off.
- Leave the door slightly ajar in order to prevent the
formation of unpleasant smells.
• Keep the machine interior clean.
• Correct loading of dishes in the machine, enables
reduced energy consumption and improved washing
and drying performance.
• Remove all large food remnants before you placing
dirty dishes into the machine.
• Operate the machine after it is completely full.
• If the appliance is located in a place where the risk of
freezing exists, you must completely drain the water
that has remained in the machine. Turn off the water
tap, disconnected the water inlet hose from the tap
and allow the interior water to drain.
H
INT
S
AND TIPS
I
f one of program monitor lights is on
and start/pause light is flashing
HINTS AND TIPS
9
Loading ...
Loading ...
Loading ...