Kenmore 66517539200 under counter dishwasher repair and replacement parts

User Manual - Page 12

For 66517539200.

PDF File Manual, 60 pages, Download pdf file

Loading ...
Loading ...
Loading ...
4. Close the dispenser cover.
It is normal for the cover to open partially when dispensing
detergent.
NOTE: Use both sections for cycles with 2 washes. Use only the
covered section for cycles with 1 wash. See the "Cycle Selection
Charts" for more details.
How much detergent to use
The amount of detergent to use depends on the hardness of
your water and the type of detergent. If you use too little,
dishes won't be clean. If you use too much in soft water,
glassware will etch.
Water hardness can change over a period of time. Find out
your water's hardness by asking your local water department,
water softener company, or county extension agent.
Different brands of dishwasher detergent have different
amounts of phosphorus for softening water. If you have hard
water and use a detergent with a phosphorous content of
less than 8.7%, you might need to use more detergent, or use
a detergent with a phosphorous content higher than 8.7%.
Water Hardness Amount of Detergent
Soft to Medium For normally soiled loads
Hard Water Partially fill the Main Wash
0 to 6 grains per section (6 tsp or 30 g)
gallon Fill the Pre-Wash section
(4 tsp or 20 g)
NOTE: Add only 2 tsp or 10 g of
detergent to the Pre-Wash section if
dishes are pre-rinsed or the water is
very soft (0to 2 grains per gallon).
For heavily soiled loads
Partially fill the Main Wash
section (7 tsp or 35 g)
Fill the Pre-Wash section
(4 tsp or 20 g)
Medium to Hard
Water
7 to 12 grains per
gallon
For normal and heavily soiled loads
Partially fill the Main Wash
section (7 tsp or 35 g)
Fill the Pre-Wash section
(4 tsp or 20 g)
Very Hard Water
13 grains per gallon
and above
NOTE: It might be
necessary to use the
Pots Pans cycle, or a
normal cycle with the
Hi Temp Scrub option
for best wash
performance with
very hard water.
For normal and heavily soiled loads
Fill the Main Wash section
(8 tsp or 40 g)
Fill the Pre-Wash section
(4 tsp or 20 g)
Turn the rinse aid dispenser to a
higher setting. See "Rinse Aid
Dispenser" later in this section.
NOTE: Fill amounts shown are for standard powdered detergent.
Amounts may vary if you use liquid or concentrated powdered
detergent. Follow instructions on the package when using liquid
dishwasher detergent or concentrated powdered detergent.
_i __c_s A _ F_ s_...... •_ _ _
Rinse aids prevent water from forming droplets that can dry as
spots or streaks, They also improve drying by allowing water to
drain off of the dishes during the final rinse by releasing a small
amount of the rinse aid into the rinse water. Your dishwasher is
designed to use a liquid rinse aid. Do not use a solid or bar-type.
Filling the dispenser
The rinse aid dispenser holds 4.8 oz (145 mL) of rinse aid. Under
normal conditions, this will last for about three months. You do
not have to wait until the dispenser is empty to refill it. Tryto keep
it full, but be careful not to overfill it.
1. Make sure the dishwasher door is fully open.
2. Turn the dispenser knob to the left and lift it out.
3. Add rinse aid until the indicator window looks full.
4. Clean up any spilled rinse aid with a damp cloth.
5. Replace the dispenser knob.
Rinse aid setting
The amount of rinse aid released into the final wash can be
adjusted. The factory setting is at 2. For most water conditions
set the adjuster to I or 2. If there are rings or calcium (hard water)
spots on dishes, try a higher setting.
°s,"s%
O
To adjust the setting
Remove the dispenser knob, then turn the adjuster inside the
dispenser to the desired setting.
©ss s e ESqcencjTps
Hot water dissolves and activates the dishwashing detergent.
Hot water also dissolves grease on dishes and helps glasses dry
spot-free, For best dishwashing results, water should be t20°F
(49°C) as it enters the dishwasher. Loads may not wash as well if
the water temperature is too low. Water that is too hot can make
some soils harder to remove and cause certain detergent
ingredients not to function, If your water heater is located far from
the dishwasher, it may be necessary to run the hot water at the
faucet closest to the dishwasher to minimize the amount of cold
water in the water line.
12
Loading ...
Loading ...
Loading ...