Loading ...
Loading ...
Loading ...
EN
User manual
9
HOW TO USE THE APPLIANCE
FIRST TIME USE
Remove any manufacturing debris:
• Select the “Cotton” programme at a temperature of 60°C.
• Pour a small quantity of detergent powder into the
main wash compartment of the detergent dispenser
(maximum 1/3 of the quantity the detergent manufacturer
recommends for lightly soiled laundry).
• Start the programme without adding any laundry (with
empty drum).
• See section “DAILY USE” for more information on how to
select and start a programme.
DAILY USE
PREPARING THE LAUNDRY
Empty pockets
• Coins, paper clips, etc. could damage the load and
the washing machine components.
• Tissues will break down during the wash cycle,
and the fragments will have to be subsequently
removed by hand.
Close all zippers, buttons, and hooks. Tie all
ribbons or belts
• Insert the smaller garments (e.g. nylon hosiery,
belts, etc.) and garments with hooks (e.g. braziers)
into a fabric bag or a pillowcase with a zipper.
Remove any rings from curtains, or else place the
curtains inside a fabric bag together with the rings.
Fabric type / Symbol on the wash label
• Cottons, mixed bres, easy care/synthetics, wool,
handwash items.
• Colour
Separate coloured and white items. Wash new coloured
articles separately.
• Size
Wash items of dierent sizes in the same wash load, to
improve washing eciency and distribution of the articles
in the drum.
• Delicates
Wash delicate items separately; they require gentle
treatment.
HOW TO USE THE WASHING MACHINE
1. Load laundry
Open the door and load the laundry. Load the
articles one at a time loosely into the drum, without
overlling. Observe the load sizes given in the
“PROGRAMME CHART” table. Overloading the machine will
result in unsatisfactory washing results and creased laundry.
2. Close door
Make sure that no laundry gets stuck between
door glass and rubber seal. Close the door so
that you can hear it click shut.
3. Open water tap
Make sure that the washing machine is connected to
the water mains. Open the water tap.
Switch on washing machine
Press the “ON/OFF” , the “Start/Pause” lamp ashes
slowly.
4. Set the desired programme
Select the required programme with the “Programme
selector” dial. The duration of the wash cycle is shown
on the display. The washing machine automatically
displays the maximum temperature and spin speed settings
possible for the selected programme. Adjust the temperature
and/or spin speed settings if needed with the relative
buttons.
Change temperature, if needed
Press the “Temperature” button to progressively lower the
temperature setting until cold wash has been set (“- -“ will
be shown on the display). Pressing the button again sets the
highest possible setting.
Change spin speed, if needed
Press the “Spin” button to progressively decrease the spin
speed until the spin cycle is turned o (“0” will be shown
on the display). Pressing the button again sets the highest
possible setting.
Select options, if needed
Press the button to select the option; the respective symbol
on display illuminates.
Press the button again to cancel the option; the light
extinguishes.
! If the selected option is incompatible with the programme
set, the incompatibility will be signalled by a buzzer (3 beeps)
and the corresponding indicator light will ash.
! If the selected option is incompatible with another
previously set option, only the most recent selection will
remain active.
Loading ...
Loading ...
Loading ...