Loading ...
Loading ...
Loading ...
17
INSTALLATION INSTRUCTIONS
IMPORTANT!
All connections must be checked for leaks.
Ensure 6mm (1/4”) tubing is routed away from sharp objects, sharp corners (beware
of kinking the tube as this will stop water flow), clear of the refrigerator rear
compartment and not in a location where it can be kinked or squashed.
Ensure all push-fit connections are firmly pushed into place. The tube should push in
16mm before reaching the stop.
If tubing is removed at any point, re-cut the end and
re-insert. Tubing must be fully inserted to avoid leaks.
To remove tube from connection points first turn off the
isolating faucet. Gently push the dispensing pad a few
times using a glass or container to remove the static line
pressure. Push in the collet firmly while pulling back on
the tubing at the same time, as shown in Diagram10.
System tested and certified by NSF International against NSF/ANSI Standard 53 for the
reduction of Asbestos, Atrazine, Benzene, Cyst, Carbofuran, Lead, Lindane, Mercury,
P-Dichlorobenzene, Toxaphene & Turbidity; against Standard NSF/ANSI42 for the
reduction of Chlorine Taste and Odour and Nominal Particulate Class I to a capacity of
2,838L (750gal).
Diagram 10
Loading ...
Loading ...
Loading ...