Loading ...
Loading ...
Loading ...
7
21 1/2"
(54.6cm)
"V" notches
in bracket
"V" notches
in bracket
Side of cabinet line
Front of cabinet line
Rear of
cabinet line
Rear Leveling leg
Screw
Installation
Floor Mount Installation
The anti-tip bracket is to be located on the
floor in the left or right rear corner of the
Refrigerated Drawers as shown in Figure 6.
Step by step instructions for locating
the position of the bracket:
1 Decide where you want to place the
Refrigerated Drawers. Slide them into
place, being careful not to damage
the floor, leaving 1" (2.5 cm) of
clearance from the rear wall to allow
room for the anti-tip bracket.
2 Raise the rear leveling legs
approximately ¼" (6 mm) to allow
engagement with the anti-tip bracket.
Level the unit by adjusting all the leveling
legs as required. Turning the leveling leg
counterclockwise will raise the unit and
clockwise will lower the unit.
CAUTION
Any finished flooring should be
protected with appropriate material to
avoid damage when moving the unit.
WARNING
TIP OVER HAZARD: One of the
rear cabinet leveling legs must be
engaged under an anti-tip bracket.
3 Make sure the Refrigerated Drawers
are in the desired location, then mark
on the floor the rear and side corner of
the cabinet where the anti-tip bracket
will be installed. If the installation does
not allow marking the rear corner of
the cabinet, then make temporary
lines on the floor marking the front
corner of the cabinet, excluding the
drawer. Slide the Refrigerated Drawers
out of the way. From the temporary
line extend the sidewall line back
21½" (54.6cm) as shown in Figure 7.
4 Align the anti-tip bracket to the marks
on the floor so the side of the bracket
lines up with the side of the cabinet
mark, and the "V" notches on the anti-
tip bracket line up with the end of the
21½" (54.6cm) line (Rear of cabinet line).
5 Fasten the anti-tip bracket to the floor
using the supplied screw. (See Figure 7).
6 Slide the cabinet back into position,
making sure the rear cabinet leveling
leg slides under the anti-tip bracket
engaging the slot.
Anti-Tip
Bracket
Leveling Leg
Front of
cabinet
21 1/2"
(54.6cm)
Bottom View of
Refrigerated
Drawer Unit
Figure 6
Loading ...
Loading ...
Loading ...