Loading ...
Loading ...
Loading ...
13
STORAGE OF ARTICLES
• At maximum loading level, the content should not block the refrigerator’s air flow or be loaded
above the load line.
• For units with interior lockers (MCLK series), breast milk should only be stored inside the locking
compartments. Water bottles or other non-perishable items can be kept on the top and bottom
shelves, but these spaces may not maintain the same level of temperature uniformity.
• Leave space around the contents to allow a smooth flow of cold air inside the cabinet. To prevent
freezing, be sure the articles do not touch the back of the interior cabinet.
• Store articles away from the inner fan.
• Shelves can be adjusted to allow proper airflow around the products being stored.
CLEANING AND MAINTENANCE
Before cleaning, it is essential that you unplug the refrigerator from the power line and transfer the
contents where they can be stored and monitored at the correct temperatures.
• Wash the inner compartment with warm water and neutral detergent. DO NOT allow the control
panel, cables or plug to get wet. NEVER use corrosive detergents, wire brushes, or abrasive
scourers to clean your refrigerator. NEVER use metal or sharp implements to remove debris.
• Dry all surfaces thoroughly.
• To ensure trouble-free operation, the condenser should be cleaned every three months where
appropriate using a vacuum hose. The condenser is located at the back of the cabinet. In
exceptionally dusty locations, the condenser should be cleaned more often.
When transporting the unit, try to keep it vertical with angle of inclination between sides of the
refrigerator and the horizontal plane not less than 50
o
. Otherwise the compressor may be affected,
disrupting normal operation of the refrigerator.
TROUBLESHOOTING
You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the servicer.
Problems
Possible causes
Remedy
The unit does not operate
Bad connection of plug or burnt out
fuse
Unplug the power cord
and re-connect the plug to
power supply or replace
with a new fuse
Abnormal operation of
the compressor or there
is a buzzing sound
The power voltage is out of rated
range
Disconnect the power
supply immediately and
reconnect with it after
normal voltage. It is
necessary to have a
voltage stabilizer in case
of poor power supply.
Loading ...
Loading ...
Loading ...