Loading ...
Loading ...
Loading ...
10
OPTION SELECTIONS
OPTIONS CAN BE
SELECTED
WITH
WHAT IT DOES ADDED
TIME TO
CYCLE
ADDED
WATER
GALLONS
(LITERS)
Dries dishes with heat. This option, with the use of
rinse aid, will provides better drying performance.
Plastic items are less likely to deform when loaded
in the top rack. Use Heat Dry for optimum dry
performance. Turn the Heat Dry option off for air dry.
Sensor
Heavy
Normal
ECO
1 Hour
Uses heating
element to speed
drying times.
Heat Dry option
defaults to On
when any cycle is
selected, except
for 1 Hour and
Rinse Only.
0:10 to
0:46
0
Raises main wash temperature to improve cleaning
for loads containing tough, baked-on food.
Sensor
Heavy
Normal
Raises the main
wash temperature
to 130°F (54°C).
0:05 to
0:13
0 to 3.86
(0 to 14.6)
Sanitizes dishes and glassware in accordance
with NSF International NSF/ANSI Standard 184
for Residential Dishwashers. Certified residential
dishwashers are not intended for licensed food
establishments. Only sanitizing cycles have been
designed to meet the requirements of the NSF/
ANSI 184 performance standard for soil removal
and for sanitization efficacy. There is no intention,
either directly or indirectly, that all cycles on a NSF/
ANSI 184 certified dishwasher meet the NSF/ANSI
184 performance standard for soil removal and for
sanitization efficacy.
At end of the cycle, the “Sanitized” indicator will
glow. If your load did not properly sanitize, the
indicator will flash at the end of the cycle. This can
happen if the cycle is interrupted, or if the water
does not reach the required temperature. The light
goes off when you open and close the door or
press CANCEL.
Sensor
Heavy
Normal
Raises the main
wash temperature
to 140°F (60°C)
and the final rinse
temperature to
156°F (69°C).
0:05 to
1:10
0 to 3.86
(0 to 14.6)
Delays the start of the cycle for 4 hours.
To delay the start:
1. Select a wash cycle and options.
2. Press DELAY WASH.
3. Press START/RESUME to begin 4 hour delay.
NOTE: If the door is opened (such as to add a dish),
the Start/Resume button must be pressed to resume
the delay countdown.
Available with
any cycle
Delays the start
of a cycle for a
maximum of
4 hours.
CONTROLS AND CYCLE STATUS
Press to start or resume a wash cycle.
If the door is opened during a cycle or the power is interrupted, the Start/Resume LED flashes. The cycle
will not resume until the Start/Resume keypad is pressed and the door is closed.
NOTE: Push door firmly closed within 4 seconds of pressing Start/Resume or the dishwasher will not
start. If door is not closed within 4 seconds the Start/Resume LED will flash and an audible tone will
sound when the door is closed.
Press to cancel a wash cycle. then, close the door firmly. The dishwasher starts a 2-minute drain
(if needed). Let the dishwasher drain completely.
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When the
Control Lock indicator is lit, all keypads are disabled. The dishwasher door can still be opened/closed
while the controls are locked.
Loading ...
Loading ...
Loading ...