Loading ...
Loading ...
Loading ...
CAUTION!
Failure to ensure the correct
assembly will cause leakage
of gas.
CAUTION!
Make sure that the gas
supply pressure of the
appliance obeys the
recommended values.
Rigid connection:
Carry out connection by using metal rigid
pipes (copper with mechanical end).
3.4 Gas selection
1. Touch for 3 seconds.
2. Within 7 seconds, touch for 3
seconds.
3. Touch 3 times.
The display shows G1 mode.
4. Touch .
To enter the mode.
5. Timer display shows selected gas
type.
6. Touch to set the gas type
according to table below.
7. Touch
.
To confirm the gas type.
Touch to exit the mode or wait for
Automatic Switch Off function activates.
Gas selection
0 1 2
Liquid gas G30/G31
30/30 mbar
Safety risk, do not use 1 or 2 gas
selections. Use only 0 gas selec-
tion depends on gas supply.
Safety risk, do not use 1 or 2 gas
selections. Use only 0 gas selec-
tion depends on gas supply.
3.5 Adjustment of minimum
level
WARNING!
Information for authorised
installer only.
Switch off the hob before
the adjustment.
To adjust the minimum level of the
burners:
1.
Touch
for 3 seconds.
2. Within 7 seconds, touch
for 3
seconds.
3. Touch
4 times.
The display shows G2 mode.
4. Touch .
To enter the mode.
5. Wait 5 seconds, after selecting the
mode.
The burner shows minimum level and the
control bar shows
.
6. Touch or .
To increase or decrease the value and
adjust the minimum level.
7. Wait 5 seconds.
To send the selected value to power
board.
8. Check it the minimum level is correct
and touch .
To confirm the minimum level.
If the minimum level is
incorrect, repeat the steps 6
and 7.
9. Touch to select the next burner
and repeat the steps 5-8.
Touch to exit the mode.
WARNING!
Make sure the flame does
not go out when you move
quickly from the maximum
to the minimum heat setting
position.
WARNING!
Do not set the G3 and G4
modes. It is for authorised
installer only.
ENGLISH 9
Loading ...
Loading ...
Loading ...